Amana ART104TFD 手册

Your model may have some or all of these features. 

The door rails may be removed for easier cleaning.

1. Depending on your model, remove the rails by pushing in 

slightly on the front of the bracket while pulling out on the 
inside tab. Repeat these steps for the other end.

2. Replace the rails by aligning the ends of the brackets with the 

buttons on the sides of the door liner. Firmly snap bracket and 
assembly onto the tabs above the shelf as shown. 

1. Remove the rails by pulling straight up on each end of the rail.
2. Replace the rails by sliding the shelf rail into the slots on the 

door and pushing the rail straight down until it stops. 

Both the refrigerator and freezer sections defrost automatically. 
However, clean both compartments about once a month to avoid 
buildup of odors. Wipe up spills immediately.
IMPORTANT: Because air circulates between both sections, any 
odors formed in one section will transfer to the other. You must 
thoroughly clean both sections to eliminate odors. To avoid odor 
transfer and drying out of food, wrap or cover foods tightly.

NOTE: Do not use abrasive or harsh cleaners such as window 
sprays, scouring cleansers, flammable fluids, cleaning waxes, 
concentrated detergents, bleaches or cleansers containing 
petroleum products on plastic parts, interior and door liners or 
gaskets. Do not use paper towels, scouring pads, or other harsh 
cleaning tool.
1. Unplug refrigerator or disconnect power.
2. Hand wash, rinse, and dry removable parts and interior 

surfaces thoroughly. Use a clean sponge or soft cloth and a 
mild detergent in warm water. 

3. Wash stainless steel and painted metal exteriors with a clean 

sponge or soft cloth and a mild detergent in warm water. Dry 
thoroughly with a soft cloth. 
NOTE: To keep your stainless steel refrigerator looking like 
new and to remove minor scuffs or marks, it is suggested that 
you use the manufacturer’s approved Stainless Steel Cleaner 
and Polish. To order the cleaner, see the “Accessories” 
section. 

IMPORTANT: This cleaner is for stainless steel parts only!

Do not allow the Stainless Steel Cleaner and Polish to come 
into contact with any plastic parts such as the trim pieces, 
dispenser covers or door gaskets. If unintentional contact 
does occur, clean plastic part with a sponge and mild 
detergent in warm water. Dry thoroughly with a soft cloth. 

4. Clean the condenser coils regularly. Coils may need to be 

cleaned as often as every other month. This may help save 
energy.

■

Pull refrigerator out away from the wall. See “Unpack the 
Refrigerator.” 

■

Vacuum coils when they are dusty or dirty.

■

Roll refrigerator back into place. Make sure to leave 1" 
(2.5 cm) between the cabinet back and the wall.

■

Check to see that the refrigerator is level.

5. Plug in refrigerator or reconnect power.