Amana ART104TFDW 手册

IMPORTANT: This refrigerator is designed for indoor, household 
use only.
To ensure proper ventilation for your refrigerator, it is 
recommended to allow a 

¹⁄₂" (1.25 cm) space on each side. Allow 

3" (7.5 cm) of space between overhead cabinets and refrigerator 
top. Allow at least 1" (2.5 cm) between back of cabinet and the 
wall. If your refrigerator has an ice maker, make sure you leave 
some extra space at the back for the water line connections.

■

If you are installing your refrigerator next to a fixed wall, leave 
enough space on the hinge side to allow for the door to swing 
open.

■

Level the refrigerator. See “Adjust the Doors.”

NOTE: This refrigerator is intended for use in a location where the 
temperature ranges from a minimum of 55°F (13°C) to a maximum 
of 110°F (43°C). The preferred room temperature range for 
optimum performance, which reduces electricity usage and 
provides superior cooling, is between 60°F (15°C) and 90°F 
(32°C). It is recommended that you do not install the refrigerator 
near a heat source, such as an oven or radiator.

Before you move your refrigerator into its final location, it is 
important to make sure you have the proper electrical connection.

A 115 volt, 60 Hz, AC only, 15- or 20-amp fused, grounded 
electrical supply is required. It is recommended that a separate 
circuit serving only your refrigerator be provided. Use an outlet 
that cannot be turned off by a switch. Do not use an 
extension cord.
NOTE: Before performing any type of installation or cleaning, or 
removing a light bulb, turn cooling off or turn the control 
(Thermostat, Refrigerator or Freezer Control depending on the 
model) to OFF, and then disconnect the refrigerator from the 
electrical source. When you are finished, reconnect the 
refrigerator to the electrical source and turn cooling on or reset the 
control (Thermostat, Refrigerator or Freezer Control depending on 
the model) to the desired setting. See “Using the Controls” in the 
User Instructions, User Guide, or Use & Care Guide.

Read all directions before you begin.
Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.
TOOLS NEEDED: Flat-blade screwdriver, 

⁷⁄₁₆" and ¹⁄₂" open-end 

wrenches or 2 adjustable wrenches, 

¹⁄₄" nut driver and drill bit, 

cordless drill. 
IMPORTANT:

■

If you turn the refrigerator on before the water line is 
connected, turn the ice maker OFF.

■

All installations must meet local plumbing code requirements.

■

Use copper tubing and check for leaks. Install copper tubing 
only in areas where the household temperatures will remain 
above freezing.

NOTE: Your refrigerator dealer has a kit available with a 

¹⁄₄" 

(6.35 mm) saddle-type shutoff valve, a union, and copper tubing. 
Before purchasing, make sure a saddle-type valve complies with 
your local plumbing codes. Do not use a piercing-type or 

³⁄₁₆" 

(4.76 mm) saddle valve which reduces water flow and clogs more 
easily.