Amana ART308FFDW 业主指南

Your model may have some or all of these features. 

The door rails may be removed for easier cleaning.

1. Depending on your model, remove the rails by pushing in 

slightly on the front of the bracket while pulling out on the 
inside tab. Repeat these steps for the other end.

2. Replace the rails by aligning the ends of the brackets with the 

buttons on the sides of the door liner. Firmly snap bracket and 
assembly onto the tabs above the shelf as shown. 

The utility compartment may be removed for easier cleaning.
To remove and replace the utility compartment:

1. Remove the utility compartment by squeezing against one 

side while raising the utility compartment up and pulling it 
straight out. 

2. Replace the utility compartment by positioning one side in the 

lock and sliding in the opposite side until it stops. 

Both the refrigerator and freezer sections defrost automatically. 
However, clean both sections about once a month to avoid 
buildup of odors. Wipe up spills immediately.
IMPORTANT:

■

Because air circulates between both sections, any odors 
formed in one section will transfer to the other. You must 
thoroughly clean both sections to eliminate odors. To avoid 
odor transfer and drying out of food, wrap or cover foods 
tightly.

■

For stainless steel models, stainless steel is corrosion-
resistant and not corrosion-proof. To help avoid corrosion of 
your stainless steel, keep your surfaces clean by using the 
following cleaning instructions.

NOTE: Do not use abrasive or harsh cleaners such as window 
sprays, scouring cleansers, flammable fluids, muriatic acid, 
cleaning waxes, concentrated detergents, bleaches or cleansers 
containing petroleum products on exterior surfaces (doors and 
cabinet), plastic parts, interior and door liners or gaskets. Do not 
use paper towels, scouring pads, or other harsh cleaning tools.
1. Unplug refrigerator or disconnect power.
2. Hand wash, rinse, and dry removable parts and interior 

surfaces thoroughly. Use a clean sponge or soft cloth and a 
mild detergent in warm water. 

3. Clean the exterior surfaces.

Painted metal: Wash painted metal exteriors with a clean, 
soft cloth or sponge and a mild detergent in warm water. 
Rinse surfaces with clean, warm water and dry immediately to 
avoid water spots.

Stainless steel: Wash stainless steel surfaces with a clean, 
soft cloth or sponge and a mild detergent in warm water. 
Rinse surfaces with clean, warm water and dry immediately to 
avoid water spots. 

NOTE: When cleaning stainless steel, always wipe in the 
direction of the grain to avoid cross-grain scratching. 

4. There is no need for routine condenser cleaning in normal 

home operating environments. If the environment is 
particularly greasy or dusty, or there is significant pet traffic in 
the home, the condenser should be cleaned every 2 to 
3 months to ensure maximum efficiency.
If you need to clean the condenser:

■

Remove the base grille.

■

Use a vacuum cleaner with a soft brush to clean the grille, 
the open areas behind the grille and the front surface area 
of the condenser.

■

Replace the base grille when finished.

5. Plug in refrigerator or reconnect power.