Perlick HA24FB31L 使用和维护

perlick.com

perlick residential installation manual

Maintenance

seasonal Maintenance for ul-aPProved
outdoor Models

Winterizing
This process should occur when the daily low
temperatures is at or below the temperatures stated
below:
Freezer models: 32° F
Refrigerator models: 38° F
Beverage Center: 42° F
Wine Reserve: 45° F

It is best to winterize your unit before the low
temperatures listed above.

1. Turn the unit to OFF position by pressing the OFF

button on the controller. The controller displays the

word “OFF” and, for Signature Series models, turn the

master switch located behind the grille off (if the power

cord is accessible, unplug the power cord. If not, turn

off the circuit breaker to the electrical receptacle the

cabinet is plugged into). For C-Series units, unplug or

turn off the circuit breaker.

2. Remove all contents from the unit.
3. Remove the front grille.
4. Clean the condenser by using a vacuum cleaner to

remove loose debris (leaves, dirt, etc.) that may have

accumulated inside the grille.

5. Reinstall the front grille.
6. Clean the interior of the unit using stainless steel cleaner

and polish (see page 9).

7. Clean the exterior of the unit using stainless steel

cleaner and polish (see page 9).

NOTE: Do not place a cover over the unit. While not required, you
may choose to remove the unit from the outdoor location and store
indoors.

Operating the unit at temperatures lower than those

recommended will void the warranty.

CAUTION

Spring Start-Up
This process should occur after the daily low temperatures
is below the temperatures stated below:
Freezer models: 32° F
Refrigerator models: 38° F
Beverage Center: 42° F
Wine Reserve: 45° F

1. Remove the grille.
2. Check the condensing unit to ensure it is clear of loose

debris, and clean as necessary with a vacuum cleaner.

3. Reattach front grille to the unit.
4. Clean the interior of the unit using stainless steel cleaner

and polish (see page 9).

5. Clean the exterior of the unit using stainless steel

cleaner and polish (see page 9).

6. Plug the unit into the electrical receptacle or turn on

the circuit breaker.

7. Turn on the master switch located behind the grille if

model is Signature Series. Press the OFF button one

time to turn the unit on. The controller display will show

the actual temperature inside the cabinet.

8. The cooling process will begin to bring the unit to the

set temperature. It’s recommended you run the unit for

24 hours to stabilize the operating temperature before

using.

DANGER

Never attempt to repair or perform maintenance on

the unit until the main electrical power to the unit has

been disconnected!

led rePlaceMent (signature series)
Call your Perlick Factory Authorized Service Center. For the
location of the Service Center in your area, contact your
selling dealer, inquire via the web at www.perlick.com,
E-mail us at warrantyserv@perlick.com, or call
(800) 558-5592 during normal business hours.

ligHt bulb rePlaceMent (c-series,

ada-coMPliant & sHallow-dePtH series)
To replace a defective or burnt out bulb, remove the glass
light cover by pulling out on the cover, unscrew the bulb
and replace it with an identical or smaller bulb. The Perlick
replacement part number is 67026.