Perlick HA24FB31L 安装指导

PERLICK RESIDENTIAL INSTALLATION MANUAL

perlick.com

SAFETY

PLEASE READ all instructions completely before attempting

to install or operate the unit. Take particular note of the

DANGER, WARNING and CAUTION information in the

manual. The information is important for the safe and

efficient installation, operation and care of your Perlick unit.

DANGER

Indicates a hazard that WILL result in serious injury or

death if precautions are not followed.

Indicates a hazard MAY cause serious injury or death if

precautions are not followed.

WARNING

Indicates a hazard where minor injury or product

damage may occur if precautions are not followed.

CAUTION

PRIOR TO INSTALLATION

Carefully inspect cabinet for hidden damage. If damage is

discovered, file your claim immediately with the transport

company. Perlick is not responsible for damage in transit.

When moving the unit, be sure

to protect finished flooring with

appropriate material to avoid damage from moving

the unit.

Do not lift unit by drawer, shelving

or door handles, as damage to the

unit could occur if not moved as instructed.

To prevent personal injury, a

minimum of two people are

required to lift the unit. Larger units may require

additional personnel.

Before moving the unit, secure the door shut with tape

to prevent door from swinging open while being moved.

Carefully move unit to installation site and place in front of

opening.

If unit has been laid on its back or

sides, place unit upright and allow

minimum of 24 hours before connecting power.

CAUTION

WARNING

CAUTION

PLUMBING

No plumbing connections are required. Condensate from

the cooling coil is automatically evaporated through a

condensate pan located in the condensing section of the

unit.

ELECTRICAL

A 115 volt, 60 Hz, 15 amp circuit breaker and electrical

supply are required. A separate circuit is required for each

Perlick unit installed.

Follow the National Electrical Code and any local codes or

ordinances when installing the receptacle.

All Perlick units come equipped with a NEMA 5-15P 90° plug

with a 5’ cord extending beyond the rear of the cabinet.

The electrical outlet must be flush with, or recessed into,

the wall surface for all HP, HC and HA models. HH models

have a recess at the rear of the cabinet to accomodate the

plug and keep a true 18” depth.

Do not attempt to operate the

equipment on any other power

source than that listed on the Electrical Specification

Plate attached to the unit.

Serious Electrocution Hazard!

Electrical grounding is required.

This appliance is equipped with a 3-prong (grounding)

polarized plug for your protection against possible

shock hazards. Failure to comply with these electrical

guidelines may result in possible death or serious

injury, fire, or loss of property.

• Never remove the round grounding prong from the

plug.

•  Never use a 2-prong adapter.
•  Never use extension cord to connect power to the unit.
•  If a 2-prong receptacle is encountered, or a longer power

cord is required, contact a qualified electrician to have it

replaced in accordance with applicable electrical codes.

ADDITIONAL GENERAL INFORMATION

• All electrical instructions assume the outlet is located

4” - 10” above the floor surface.

• Floor must be level in area of installation. Leg levelers

are used for fine-tune adjustment only and should not

be used to compensate for floor differences exceeding

1/2”.

DANGER

CAUTION