Liebherr HC1080 安装指导

Ventilation  from  underneath  through  the  floor  of  the

kitchen cabinet can be set up with the supplied ventilation

grid

 Fig. 7 (3)

 or an air vent with at least a 31 in

2

 (200 cm

2

)

cross section area. If you use the supplied ventilation grid

Fig. 7 (1)

 please proceed as follows:

Fig. 7 

u

Cut a hole 17-23/32 in. (450 mm) wide and 2-7/32 in.

(56 mm) high in the floor of the kitchen cabinet.

u

Insert the ventilation grid

 Fig. 7 (1)

 into the cut out in the

cabinet floor

 Fig. 7 (2)

.

u

Slide  the  snap  connectors

  Fig.  7  (3)

  into  the  grid  from

behind until the hooks touch the cabinet floor.

u

Fit  the  cabinet  floor  (with  the  ventilation  grid  snapped

into place) into the cabinet.

Risk of bodily injury due to the door falling off.

If  the  fasteners  are  not  installed  with  the  proper  torque,

the door may fall off. In addition, the door may not close,

thus impairing the cooling performance of the appliance.

u

Tightly  secure  the  hinges  along  ball  stud  of  the  soft

stop mechanism by applying a torque of 3 lb-ft (4 Nm).

u

Tighten  the  soft  stop  mechanism  retainer  firmly  with

2.5 lb-ft (3 Nm).

u

Check all screws and retighten if necessary.

The  door  stop  can  only  be  changed  if  there  is  sufficient

space above to remove the hinge fixing bracket and fit it

on the opposite side again. This is not normally the case

when installing in a recess.

u

Change the door stop before the appliance is installed

in the recess.

There is the risk of injury when doing this. Obey the

safety instructions.
The instructions apply to several models. Only perform

this step if it applies to your appliance.

Select one of the alternatives shown.

Only undo the screw. Don't take it out.

Check the screws and if necessary tighten them.

Required tool:

Fig. 8 

Fig. 9 

Risk of injury if soft stop contracts!

u

Carefully remove soft stop damper.

u

Removing the soft stop damper: Remove the soft stop

damper from the ball stud (1). Unscrew the retainer (2).

Remove the ball stud with a screwdriver (3).