Thermador WDC30J 安装指导
Attach Custom Drawer Front
1. On the back side of the panel, mark the pilot holes of
the custom drawer front at the locations and
specifications indicated in Figure 5 and Figure 6.
specifications indicated in Figure 5 and Figure 6.
2. Drill pilot holes. Be careful not to drill all the way
through the panel! Pilot holes should only be 7/16”
(11 mm) deep.
(11 mm) deep.
3. Attach drawer front with four (4) 1/2” (12.7 mm) screws
through the back side of drawer front (Figure 7).
Installation Procedure
1. Turn power OFF at the service panel. Lock service
panel to prevent power from being turned ON.
2. Install electrical connection and prepare cabinet cutout
according to the dimensions for the applicable model
stated in “General Information”.
stated in “General Information”.
--
SUGGESTION
Saw blades can splinter and chip cabinet facing. To
better protect cabinetry, after measuring and marking
the cut line with a pencil, cover the wood with a piece of
masking tape along the top of the line to be cut.
Saw blades can splinter and chip cabinet facing. To
better protect cabinetry, after measuring and marking
the cut line with a pencil, cover the wood with a piece of
masking tape along the top of the line to be cut.
3. Position the anti-tip bracket on the floor of cabinet
opening 20
⅝
” (524 mm) from the cabinet edge and
Figure 7: Custom Front Panel Installation
1
Custom front panel
Custom front panel
Custom front panel
2
CAUTION:
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally.
Lock service panel to prevent power from being turned
ON accidentally.
CAUTION:
It is recommended to have two installers to
install warming drawer. Failure to do so may
result in property damage or personal injury.
install warming drawer. Failure to do so may
result in property damage or personal injury.