Amana PTC093G50CXXX 业主指南

下载
页码 20
14
OBTAINING SERVICE
In the event this unit requires repair or servicing beyond what is
covered in this manual, contact an authorized service organiza-
tion.
To obtain an authorized servicer, contact your sales representa-
tive or agency.
NORMAL OPERATING
SOUNDS AND CONDITIONS
Water trickling sounds
Water is picked up and distributed over the coil. This
improves the efficiency and helps with water removal.
Water dripping
Water will collect in the base pan during high humidity days.
This can cause overflow and drip from the outside of the unit.
Air sounds
The fan cycle switch sets the operational mode of the fan in
the ON position. The fan will run continuously whenever
power is applied in this mode.  In the AUTO position, the fan
will cycle on and off with  the compressor or electric heater.
Starting delay
You may notice a few minutes delay in the starting if you
try to restart the unit too soon after turning it off or if you
adjust the thermostat right after the compressor has shut
off. This is due to a built in delay to protect the compres-
sor.
CONFIGURATION SETTINGS
7 BUTTON TOUCH PAD WITH DISPLAY
The control can be configured to operate a wide range of
options.  The options listed below with the * are the factory
default settings.  If these are acceptable, then the unit does not
require any additional configuration and is fully operable.  
To
configure the unit, first select the configuration feature
code setting and then an option code to change from the
factory default setting.
To enter configuration feature mode:
1. Press and hold the up and down 
 arrow keys at the
same time and press  the  OFF 
  key  twice within a
two (2) second time frame.   The display will indicate - -.,
and then release the 
 key and press the 
 key one
time. The display will then alternate between C1 and 0.
To select a different configuration feature code, press the
HEAT 
  key until the desired configuration comes
up. To scroll to a previously viewed configuration codes
press the COOL  
 key.
Once you have scrolled to the correct feature, then to se-
lect the option code for your desired configuration, press
either the up or down key 
  to scroll through the op-
tions of the selected feature code.
To exit configuration mode:
1. Press the OFF  
 key.  Configuration feature mode
will also exit if no keys are pressed for a period of two
(2) minutes
.