Liebherr HCB1561 安装指导
3
I
nstallatIon
G
uIdelInes
To protect the appliance from possible
damage, allow the appliance to stand
1/2 to 1 hour in place before turning the
electricity on. This allows the refrigerant
and system lubrication to reach
equilibrium.
Customer’s Responsibility
A 115 Volt, 60 Hz, 15 Amp fused electrical supply
is required. We recommend using a dedicated
circuit for this appliance to prevent electrical
overload. Follow the National Electrical Code and
local codes and ordinances when installing the
receptacle.
Blocking for Safety
The anti tipping brackets must be installed to
prevent the unit from tipping after it is installed.
Refer to Blocking for Safety.
Unit Venting
Do not restrict the air flow. Air flow must be
provided for the unit to operate.
Area Requirements
Verify the following:
• Floors can support the appliance’s weight plus
approximately 1200 pounds (544 kg) of food
weight.
• Finished kitchen floor height is level. Appliance
must be shimmed level if the floor heights
are not equal to make sure air vents are not
obstructed.
• Remove anything attached to rear or side walls
that can obstruct appliance opening.
• Cutout dimensions are accurate.
• Electrical outlet is in correct location.
Do not install this refrigerator-freezer next to any
other refrigerator. Installing this refrigerator-freezer
next to any other refrigerator or freezer can cause
condensation or cause damage to the appliance.
Electrical Requirement
If codes require a separate grounding circuit to be
used, have a qualified electrician install the circuit.
Do not ground to a gas pipe. Check with a
qualified electrician if you are not sure the
appliance is properly grounded. Do not
have a fuse in the neutral or grounding
circuit.
ELECTROCUTION HAZARD
Electrical grounding required. This
appliance is equipped with a three-
prong (grounding) polarized plug for
your protection against possible shock
hazards.
• Do not remove the round grounding
• Do not remove the round grounding
prong from the plug.
• Do not use a two-prong grounding
• Do not use a two-prong grounding
adapter.
• Do not use an extension cord to
• Do not use an extension cord to
connect power to the unit.