Frigidaire MWV150KB 安装指导

Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall 
to mount the plate.

Before tightening toggle bolts and wood

screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed 
flush against the wall and that the plate is properly
centered under the cabinet.
CAUTION: 

Be careful to avoid pinching fingers

between the back of the mounting plate and the wall.

Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.

Attach the plate to the wall using toggle bolts. 
At least one wood screw must be used to attach 
the plate to a wall stud.

Remove the toggle wings from the bolts. 

Insert the bolts into the mounting plate 
through the holes designated to go into drywall
and reattach the toggle wings to 

3

⁄

4

″ (19 mm) onto

each bolt. 

Attach Mounting Plate to Wall

Prepare Top Cabinet

Mount Microwave Oven

Adjust Exhaust Adaptor

Wall

Mounting

Plate

Spacing for Toggles
More Than Wall
Thickness

Bolt End

Toggle 
Bolt

Toggle Wings

Make sure the screws for the 
blower motor and blower plate 
are securely tightened when 
they are reinstalled. This will 
help to prevent excessive 
vibration.

Make sure the motor wiring has 
been properly routed and secured, 
and that the wires are not pinched.

Connect Ductwork

Check Damper Operation

Adapting Microwave Blower for 

Outside Top Exhaust