Viking VEWD530CB 安装指导
Installation - VEWD & DEWD
11
1
2
1
2
Pull out warming drawer
pan until fully extended.
pan until fully extended.
Slide finger along right and left side until you reach the
black hand latches (located at the front of the rails). Pull
up on both the right and left latches and pull out
drawer pan support.
3
Outdoor only
Outdoor only
Outdoor only
2”
(5.1 cm)
2”
(5.1 cm)
Electrical opening
(from rear)
4
Apply silicone caulk around the back
of the warming drawer trim.
Note: For outdoor models ONLY.
2
1
1
5
Feed supply cord up through
hole in rear of warming drawer.
Remove strain relief bracket and mounting
screws on the terminals.
1
2
6
Attach the white (neutral) and black (line) lead
terminals. Attach ground wire to the
center terminal.
General Information
10
• When installing this unit directly below
other units, only install with Viking built-
in products.
in products.
• Remove warming drawer carefully from
carton. Remove all loose packaging and
accessories.
accessories.
• It is the responsibility of the installer to
comply with local codes. If no local
codes are applicable, wire in accordance
with the National Electrical Code,
ANSI/NFPA 70 - latest edition.
codes are applicable, wire in accordance
with the National Electrical Code,
ANSI/NFPA 70 - latest edition.
• This appliance is not fused. Protect
with a proper sized fuse or circuit
breaker and a GFI for outdoor models.
breaker and a GFI for outdoor models.
• Line disconnect switch, circuit breaker,
GFI (for outdoor models) or
plug/receptacle of power cord
connection should be readily accessible
to the operator.
plug/receptacle of power cord
connection should be readily accessible
to the operator.
• Ground unit per applicable electrical
codes.
• Any installation not matching the
specifications discussed in these
instructions will void the manufacturer’s
warranty.
instructions will void the manufacturer’s
warranty.
READ AND FOLLOW ALL WARNING
AND CAUTION INFORMATION
WHEN INSTALLING THIS APPLIANCE.
AND CAUTION INFORMATION
WHEN INSTALLING THIS APPLIANCE.
Moving, Handling and Unpacking
Remove and discard all packing materials,
including cardboard and tape on the
outside and inside of the warming drawer.
Remove and discard all packing materials,
including cardboard and tape on the
outside and inside of the warming drawer.
Some stainless steel parts may have a
plastic protective wrap which must be
peeled off. The interior should be washed
thoroughly with hot, soapy water to remove
film residues and any dust or debris before
being used, then rinsed and wiped dry.
Solutions stronger than soap and water are
rarely needed.
plastic protective wrap which must be
peeled off. The interior should be washed
thoroughly with hot, soapy water to remove
film residues and any dust or debris before
being used, then rinsed and wiped dry.
Solutions stronger than soap and water are
rarely needed.