GE CSB9120SJSS 规格说明表单
Specification Created 5/15
CSB9120SJ
GE Café
™
Series 30" Single Wall Oven with Advantium
®
Technology
Installation over a GE/Monogram
Warming Drawer:
30”
23-1/2”
25-1/4”
Min.
21”
2” Min.
(3” recommended)
(3” recommended)
Per warming
drawer
requirement
Construct
Solid Bottom
Min. 3/8”
Plywood
Supported
by 2x4 or 2x2
Runners all
Four Sides
5” min.
from floor
1” min.
above
toekick
Warming Drawer:
Construct Solid
Bottom Min.
3/8” Plywood
Supported by
2x4 or 2x2
Runners all
Four Sides
30”
23-1/2”
21”
2” Min.
Per Oven
Requirement
Per warming drawer requirement
2” Min.
(3” recommended)
(3” recommended)
25-1/4”
Min.
5” min.
from floor
1” min.
above
toekick
PREPARE THE OPENING (CONT.)
When installed over a single oven or a
warming drawer, allow at least 2" between
When installed over a single oven or a
warming drawer, allow at least 2" between
the two openings. This separation will
provide clearance for bottom overlap of
provide clearance for bottom overlap of
the Advantium and the other appliance
overlaps.
Construct a solid oven floor of 3/8" min.
thick plywood supported by 2 x 4 or 2 x 2
runners on all sides.
• The support must be level and rigidly
overlaps.
Construct a solid oven floor of 3/8" min.
thick plywood supported by 2 x 4 or 2 x 2
runners on all sides.
• The support must be level and rigidly
mounted, flush with the bottom edge of
the cutout.
the cutout.
NOTE: Additional clearances between the
cutouts may be required. Check to be sure
the oven supports above the Warming
Drawer location do not obstruct the
Drawer location do not obstruct the
required interior depth and height. See
Warming Drawer installation instructions
for details.
for details.
INSTALLATION OVER A GE/
MONOGRAM OVEN AND WARMING
DRAWER:
NOTE: Additional clearances between the
cutouts may be required. Check to be sure
the oven supports above the Warming
the oven supports above the Warming
Drawer location do not obstruct the
required interior depth and height. See
required interior depth and height. See
Warming Drawer installation instructions
for details.
CAUTION: For personal safety, the
for details.
CAUTION: For personal safety, the
mounting surface must be capable of
supporting the cabinet load, in addition
to the added weight of this approximate
to the added weight of this approximate
80-pound oven and 30-pound drawer, plus
additional oven loads of up to 50 pounds
or a total weight of 160 pounds.
or a total weight of 160 pounds.
PREPARATION WITH AN ACCESSORY DRAWER
PREPARE THE OPENING
The Advantium 120V can be installed in combination with other
GE/Monogram appliances. Always follow each product's Installation
The Advantium 120V can be installed in combination with other
GE/Monogram appliances. Always follow each product's Installation
Instructions to compete the installation.
SINGLE OVEN INSTALLATION:
SINGLE OVEN INSTALLATION:
Order a 30" wide single oven cabinet or cut the opening in a wall to the
dimensions shown.
dimensions shown.
* For existing cutouts, a maximum
width of 28-1/2" is acceptable.
If the opening is slightly wider,
secure a furring strip on each
side of the cutout for securing the
oven.
If the opening is slightly wider,
secure a furring strip on each
side of the cutout for securing the
oven.
• Allow 3/4" to 2-1/8" case trim
overlap on the sides and 7/8"
overlap on the bottom of the
overlap on the bottom of the
opening for all models. The
amount of overlap on the sides
depends on the actual cutout
width. Allow 1-1/4" case trim
overlap on the top for models PSB9120 and for models ZSC1201
amount of overlap on the sides
depends on the actual cutout
width. Allow 1-1/4" case trim
overlap on the top for models PSB9120 and for models ZSC1201
and ZSC1202.
• Oven overlaps will conceal cut edges on all sides of the opening.
NOTE: PSB9120 series Advantium can be installed below GE/GE
NOTE: PSB9120 series Advantium can be installed below GE/GE
Profile non-downdraft gas and electric cooktops. It CANNOT be
installed below induction or Monogram (2GU3841385) gas cooktops.
NOTE: PSB9120 series Advantium oven comes with two lower trim
NOTE: PSB9120 series Advantium oven comes with two lower trim
pieces. One is for use above 36-inch height installations and one is
for use below 36-inch installations. Use of the accessory drawer will
replace the bottom trim piece for applicable installations. Please see
for use below 36-inch installations. Use of the accessory drawer will
replace the bottom trim piece for applicable installations. Please see
installation instructions for full details.
30”
23-1/2”
25-1/4”
Min.
21”
Construct
Base
Min. 3/8”
Plywood
Supported
by 2x4 or 2x2
Runners all
Four Sides
5” min.
from floor
1” min.
above
toekick