Monogram ZTD910SFSS 安装指导
11
SECURE CUSTOM PANEL
TO METAL MOUNTING PANEL
TO METAL MOUNTING PANEL
• Lay the custom panel, appearance side down,
on a clean surface.
• Place the flat side of the metal panel onto the back
side of the custom panel, with the mounting flanges
facing up.
facing up.
• Align the lamp hole in the panel with the mounting
panel.
• Check top, bottom and side overlap dimensions
from the metal panel to wood panel edge as shown.
3/16"
1/4"
7/32"
1/4"
Top
Bottom
Align Holes
Handle
Attachment Holes
FOR PANELS LESS
THAN 3/4" THICK
THAN 3/4" THICK
• Separate the custom panel and metal panel.
• Apply a few horizontal beads of adhesive
• Apply a few horizontal beads of adhesive
to the metal panel. Avoid adhesive within 1"
of lamp hole area and outer edges.
of lamp hole area and outer edges.
FOR 3/4" (OR GREATER)
THICK PANELS
THICK PANELS
3/4" thick panels may be secured to the metal panel
with screws.
• Use the metal panel as a template. Position the metal
with screws.
• Use the metal panel as a template. Position the metal
panel over the back side of the custom panel and drill
pilot holes. Drill pilot holes sized to match screws being
used (screws not provided).
pilot holes. Drill pilot holes sized to match screws being
used (screws not provided).
CAUTION:
Select screw length carefully
to avoid penetration of the finished side.
INSTALL LAMP JEWEL
Turn the assembly appearance side up.
• Use plastic to wood adhesive to secure the lamp
• Use plastic to wood adhesive to secure the lamp
jewel to the front of the wood panel. On the side
with the bulge, (see illustration) apply a small
bead of adhesive around the outside edge.
Place the jewel into the drilled hole.
with the bulge, (see illustration) apply a small
bead of adhesive around the outside edge.
Place the jewel into the drilled hole.
Insert
Jewel
Jewel
Appearance
Side
Side
This Side
Against
Wood
Against
Wood
REINSTALL ORIGINAL
HANDLE OR OPTIONAL
CUSTOM HANDLE
HANDLE OR OPTIONAL
CUSTOM HANDLE
A custom handle (not supplied) may be installed.
• Drill pilot holes through the front of the custom
• Drill pilot holes through the front of the custom
panel and through the metal panel to match
the chosen handle.
the chosen handle.
NOTE: The handle screws should be installed through
the metal panel, the custom panel and into the custom
or original handle.
the metal panel, the custom panel and into the custom
or original handle.
INSTALL ASSEMBLED PANEL
TO THE DRAWER
TO THE DRAWER
• Install the custom panel assembly to the exposed
drawer front using the original 7 screws.
Custom Handle
or Original Handle
Back side of Appearance Panel with Support Panel
Installation
STEP 4
STEP 5
STEP 5A
STEP 6
STEP 7
STEP 8