Whirlpool WUB50X24EM 业主指南

4

 

■

Remove tape and glue residue from surfaces before turning 

on the beverage center. Rub a small amount of liquid dish 

soap over the adhesive with your fingers. Wipe with warm 

water and dry.

 

■

Do not use sharp instruments, rubbing alcohol, flammable 

fluids, or abrasive cleaners to remove tape or glue. These 

products can damage the surface of your beverage center. 

For more information see “Beverage Center Safety.”

 

■

Dispose of/recycle all packaging materials.

To ensure proper ventilation for your beverage center, allow for a 

¼" (6.35 mm) space on each side and at the top. When installing 

your beverage center next to a fixed wall, leave 2½" (6.35 cm) 

minimum clearance on the hinge side to allow for the door to 

swing open.
NOTE: It is recommended that you do not install the beverage 

center near an oven, radiator, or other heat source. Do not install 

in a location where the temperature will fall below 55°F (13°C). 

For best performance, do not install the beverage center behind  

a cabinet door or block the base grille.

Before you move your beverage center into its final location, 

it is important to make sure you have the proper electrical 

connection.
Recommended Grounding Method
A 115 volt, 60 Hz, AC only, 15- or 20-amp fused, grounded 

electrical supply is required. It is recommended that a separate 

circuit serving only your Beverage Center be provided. Use 

an outlet that cannot be turned off by a switch. Do not use an 

extension cord.
NOTE:  Before performing any type of installation, cleaning, 

or removing a light bulb, disconnect the beverage center from 

the electrical source. When you have finished, reconnect the 

beverage center to the electrical source.