Amana ART318FFDW 业主指南

IMPORTANT: Provide additional support for the doors while the 
hinges are being moved. Do not depend on the door magnets to 
hold the doors in place while you are working.

1. Place the plastic spacer beneath the hinge so that it will be 

between the hinge and the cabinet, making sure the holes are 
aligned. 

2. Fasten the top hinge to the opposite side of the cabinet, 

inserting the screws only halfway, so you will be able to 
replace and align the freezer door later.

1. Insert the bottom hinge pin into the bottom hinge and fasten 

the hinge to the cabinet. Do not tighten completely. 

2. Place the washer on top of the bottom hinge pin.
3. Place the refrigerator door onto the pin of the bottom hinge.

4. Measure the distance from the bottom of the refrigerator door 

to the floor. The distance should be approximately 1

⁴⁄₅" 

(4.6 cm). 
NOTE: If necessary, loosen the bottom hinge, without 
removing the screws, adjust the door to the correct height and 
fully tighten the screws. 

1. Place washer on the upper hinge pin of the center hinge. 
2. Place the freezer door on the upper hinge pin of the center 

hinge. 

3. Insert the top hinge pin into the drilled hole in the top of the 

freezer door. Do not tighten the screws completely. 

4. Align the doors so that the bottom of the freezer door aligns 

evenly with the top of the refrigerator door. Tighten all screws.
NOTE: The distance between the doors should be 
approximately 

³⁄₄" (19 mm).

1. Plug into a grounded 3 prong outlet.
2. Reset the controls. See “Using the Control(s).”
3. Return all removable door parts to doors and the food to the 

refrigerator.