Whirlpool WOC97ES0ES 安装指导

1.   Connect the 2 black wires (C) together using a UL-listed wire 

connector.

2.   Connect the 2 white wires (D) and the green (or bare) ground 

wire (of the oven cable) using a UL-listed wire connector.

3.   Connect the 2 red wires (G) together using a UL-listed wire 

connector.

4.  Install junction box cover.

1.   Using 2 or more people, lift oven partially into cabinet  

cutout. Use the oven opening as an area to grip.
NOTE: Push against seal area of oven front frame when 

pushing oven into cabinet. Do not push against outside 

edges.

2.   Push against the seal area of the front frame to push the 

oven into the cabinet until the back surface of the front 

frame touches the front wall of the cabinet.

3.   Push oven completely into cabinet and center oven into 

cabinet cutout.

4.  Remove the tape from black front trims.

■

 

Securely fasten the oven to the cabinet using the #8-14  

x ¾" screws provided.

■

 Insert the screws through holes in black trim aligning with 

holes in oven frame. Do not overtighten screws.

  5.  The bottom vent is shipped in the foam packing at the top  

of the oven. Install the bottom vent (C) as follows:

■

Align vent tab (B) with oven frame (A) as shown.

■

 Using one #8-18 x ³⁄

8

" screw (D) on each side of the vent 

tab (B), fasten the vent securely to the oven.

  6.  Replace oven racks.
  7.  Replace the oven door. See the “Replace Oven Door(s)”  

section.

  8.  Check that door is free to open and close. If it is not,  

repeat the removal and installation procedures. See  

“Prepare Built-In Microwave/Oven Combination” section.

  9. Reconnect power.
10.  The display panel will light briefly, and “PF” should appear 

in the display.

11.  If the display panel does not light, please reference  

the “Warranty” section of the Use and Care Guide.

On combo microwave/oven models installed above a warming 

drawer, a warming drawer deflector kit must be installed.  

See the “Tools and Parts” section for ordering information.