Amana ASD2575BRB 业主指南

1. Using a sturdy container, depress and hold the water 

dispenser lever for 5 seconds, then release it for 5 seconds. 

2. Repeat Step 1 until water begins to flow. 
3. Once water begins to flow, continue depressing and releasing 

the dispenser lever (5 seconds on, 5 seconds off) until a total 
of 3 gal. (12 L) has been dispensed. 

Additional flushing may be required in some households.

■

Dispense at least 1 qt (1 L) of water every week to maintain a 
fresh supply.

■

If the flow of water from the dispenser decreases, it could be 
caused by low water pressure.

■

With the water filter removed, dispense 1 cup (237 mL) of 
water. If 1 cup of water is dispensed in 8 seconds or less, 
the water pressure to the refrigerator meets the minimum 
requirement.

■

If it takes longer than 8 seconds to dispense 1 cup of 
water, the water pressure to the refrigerator is lower than 
recommended. See “Water Supply Requirements” or 
“Problem Solver” for suggestions.

1. Press the WATER button to select water.  

2. Press a sturdy glass against the dispenser lever. Hold the 

glass close to the water dispenser spout to ensure that the 
water dispenses into the glass.    

3. Remove the glass to stop dispensing.
IMPORTANT: The small tray at the bottom of the dispenser is 
designed to catch small spills and allow for easy cleaning. There is 
no drain in the tray. To empty and clean the tray, push down on 
the back of the removable tray lid and pull it out. 

Ice dispenses from the ice maker storage bin in the freezer when 
the dispenser lever is pressed. To turn off the ice maker, see “Ice 
Maker and Storage Bin.”
Your ice maker can produce both crushed and cubed ice. Before 
dispensing ice, select which type of ice you prefer. 

■

Press the CRUSHED button for crushed ice, or the CUBED 
button for cubed ice.  

For crushed ice, cubes are crushed before being dispensed. This 
may cause a slight delay when dispensing crushed ice. Noise 
from the ice crusher is normal, and pieces of ice may vary in size. 
When changing from crushed to cubed, a few ounces of crushed 
ice will be dispensed along with the first cubes.

1. Press the button to select the desired type of ice.

2. Press a sturdy glass against the ice dispenser lever. Hold the 

glass close to the ice guide to ensure that the ice dispenses 
into the glass.     

IMPORTANT: You do not need to apply a lot of pressure to the 
lever in order to activate the ice dispenser. Pressing hard will 
not make the ice dispense faster or in greater quantities.

3. Remove the glass to stop dispensing.

A

A