Amana ADB1700ADB-BB 安装指南

Form bare ground wire into a U-shaped hook. Wrap ground wire 
hook clockwise around the ground connector screw on the raised 
floor inside the box and under the washer. Securely tighten 
ground connector.

Select UL Listed/CSA Approved twist-on wire connectors of the 
proper size. See the “Tools and Parts” section at the front of the 
guide for part details. Connect wires, black to black and white to 
white, using the twist-on wire connectors.
NOTE: Do not pre-twist stranded wire. Twist on wire connector. 
Gently tug on wires to be sure both are secured.

 

Tighten strain relief screws to secure cable. Make sure screw 
heads are facing up when tightening conduit nut.

Place wires inside terminal box. Replace the cover by inserting the 
hooks of the terminal cover into the slots in the floor of the 
terminal box and sliding the cover tight against the back wall 
where wires come in. Make sure wires are tucked inside the box 
and not pinched by the cover. Then, put the terminal box back on 
the crossbar with the tab in place. Use a 

¹⁄₄" nut driver and the 

previously removed screw to secure the terminal box to the 
crossbar.
Once the terminal box has been remounted on the dishwasher, 
there should be some excess length or slack in the green, black, 
and white wires coming from the dishwasher to the terminal box. 
Wrap these wires over the nearby components, or clip them back 
into the nearby clips that they were routed through prior to your 
removing the box, to help keep them off the floor.