Amana ASD2275BRW 业主指南

■

New installation - Following installation, allow 24 hours for the refrigerator and freezer to cool 
completely.

NOTE: Adjusting the temperature control(s) to the coldest setting will not cool either 
compartment (refrigerator or freezer) more quickly.

■

Doors are opened often or not closed completely - This allows warm air to enter the 
refrigerator. Minimize door openings, keep the doors fully closed, and make sure both doors are 
properly sealed. 

■

Air vents are blocked - Remove items that are immediately in front of the vents.

■

Large amount of warm food recently added - Allow several hours for the refrigerator to return 
to its normal temperature. 

■

Controls are not set correctly for the surrounding conditions - Adjust the controls to a colder 
setting. Check the temperature again in 24 hours.

■

Controls are not set correctly for the surrounding conditions - Adjust the controls to a 
warmer setting. Check the temperature again in 24 hours. 

■

Top refrigerator shelf is colder than lower shelves - On some models, air from the freezer 
enters the refrigerator compartment through vents near the top refrigerator shelf. As a result, the 
top shelf can be slightly colder than lower shelves. 

■

Air vents are blocked - Remove items that are immediately in front of the vents.

NOTE: Some moisture buildup is normal. Clean with a soft dry cloth.

■

Room is humid - A humid environment contributes to moisture buildup. Use the refrigerator only 
in an indoor location, with as little humidity as possible.

■

Doors are opened often or not closed completely - This allows humid air to enter the 
refrigerator. Minimize door openings, keep the doors fully closed, and make sure both doors are 
properly sealed. 

■

Doors have been open for an extended period of time - Close the doors to reset the lights.

■

Light bulb is loose in the socket or has burned out - On models with incandescent interior 
light bulbs, tighten or replace the bulb. See “Lights.”

NOTE: On models with LED lights, call for assistance or service if the interior lights do not illuminate 
when either door is opened. See either the front cover or the Warranty for contact information.

■

Dispenser light is turned off - On some models, if the dispenser light is set to OFF, the light will 
turn on only when a dispenser pad/lever is pressed. If you want the dispenser light to stay on 
continuously, select a different setting. See “Water and Ice Dispensers.”

■

Dispenser light is set to AUTO or NIGHT LIGHT - On some models, if the dispenser light is set 
to AUTO or NIGHT LIGHT, make sure the dispenser light sensor is not blocked. See “Water and 
Ice Dispensers.”

NOTE: On models with LED lights, call for assistance or service if the dispenser lights do not operate 
correctly. See either the front cover or the Warranty for contact information.

■

Gaskets are dirty or sticky - Clean the gaskets and contact surfaces with mild soap and warm 
water. Rinse and dry with a soft cloth.

■

Door is blocked open - Move food packages away from the door. Make sure all bins and 
shelves are in their correct positions. Make sure all packaging materials have been removed.