Whirlpool WDF110PABB-BL 业主指南

NOTE: Run hot water at the sink nearest your dishwasher until the 
water is hot. Turn off water.

■

If the Start/Resume button is located on top of door; push door 
firmly closed within 3 seconds of pressing START/RESUME. If door 
is not closed within 3 seconds, the Start/Resume button LED will 
flash, an audible tone will be heard, and cycle will not start.

IMPORTANT: If anyone opens the door (such as, for adding a dish, 
even during the Delay Hours option), the START/RESUME button must 
be pressed each time. 

■

If your Start/Resume button is located on front of door: push door 
firmly closed. The door latches automatically. Select the wash 
cycle, options and press START/RESUME or press 
START/RESUME to repeat the same cycle and options as in 
previous wash cycle.

This information covers several different models. Your dishwasher may not have all of the cycles and options described. 

Use for hard-to-clean, heavily soiled pots, pans, casseroles, and 
tableware. 

122

125

7.47 (28.28)

This cycle with only the Heated Dry option selected, and without 
other options selected, is recommended to completely wash 
and dry a full load of normally soiled dishes. The energy usage 
label is based on this cycle and option combination.

88

91

3.01 (11.38)

For fast results, 1-Hr Wash will clean dishes using slightly more 
water and energy. Selecting the Heat Dry option will increase 
total cycle time but dry dishes faster than air drying alone. 

59

62

5.80 (21.94)

Raises main wash temperature to improve 
cleaning for loads containing tough, baked-
on food.

Increases the 
temperature of the 
main wash and 
increases the water 
used in prewash and 
rinses, improving 
wash performance.

23

25

2.79 (10.56)

Dries dishes with heat. Plastic items are less 
likely to deform when loaded in the top rack. 
Turn the Heat Dry option off for air dry.

Turns on the heat 
element at the end of 
the wash cycle for 
better dry 
performance.

49

49

0

Press to start or 
resume a wash 
cycle.

If the door is opened during a cycle or the power is interrupted, the Start/Resume button LED flashes. Cycle 
will not resume until door is closed and START/RESUME is pressed.

NOTE: If Start/Resume button is located on top of door, push door firmly closed within 3 seconds of pressing 
START/RESUME. If door is not closed within 3 seconds, Start/Resume button LED will flash, an audible tone 
will be heard (on some top control models), and cycle will not start.

Press to cancel 
wash cycle.

Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let dishwasher drain completely.

To follow progress 
of your 
dishwasher cycle. 

The Clean indicator glows when a cycle is finished.