Samsung ME18H704SFG/AA 安装指导

16

Wall

Toggle Wings

Toggle

Bolt

Bolt End

Spacing for Toggles More 

Than Wall Thickness

Mounting 

Plate

3.  Place the mounting plate against the wall, pinch 

the wings of each toggle together, and then insert 

the toggle wings of each toggle into and through 

the holes in the wall.

NOTE: Before tightening the toggle bolts and wood 

screw, make sure the bottom of the Mounting plate 

runs along the bottom Horizontal line of the “Rear wall 

Template” and the Mounting plate is properly centered 

under the cabinet.

CAUTION: Be careful to avoid pinching your fingers 

between the back of the mounting plate and the wall.

4.  Tighten all bolts. Pull the plate away from the wall 

to help tighten the bolts. Tighten the screw.

You need to drill holes for the top support screws and 

a hole large enough for the power cord to fit through.

•  Read the instructions on the TOP CABINET 

TEMPLATE.

•  Tape it underneath the top cabinet.
•  Drill the holes, following the instructions on the 

TOP CABINET TEMPLATE.

CAUTION: Wear safety goggles when drilling holes in 

the cabinet bottom.

FOR EASIER INSTALLATION AND PERSONAL 

SAFETY, WE RECOMMEND THAT TWO PEOPLE 

INSTALL THIS MICROWAVE OVEN.

NOTE: If your cabinet is metal, use the nylon 

grommet in the power cord hole to prevent the cord 

from being cut.

NOTE: Filler blocks are required when mounting this 

unit under any cabinet with a recessed bottom or 

front overhang. (See page 9.)

NOTE: When mounting the microwave oven, thread 

the power cord through hole in the bottom of the top 

cabinet. Keep it tight throughout Steps 1–3. Do not 

Grease Filter

Grease Filter

SMH1927_XAA_DE68-04108A-02_EN_120725.indd   16

5/3/2013   8:45:23 AM