Maytag MED8100DW-WW 安装指导

Remove protective cap from  

water inlet valve. Attach other end  

of long hose to fill valve at bottom of dryer  

back panel. Screw on coupling by hand until it is seated on 

fill valve connector. Using pliers, tighten the couplings an 

additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling  

can result.

Check that the water faucets are turned on.

Using a 4" (102 mm) clamp, connect vent to exhaust outlet  

in dryer. If connecting to existing vent, make sure vent is 

clean. Dryer vent must fit over dryer exhaust outlet and inside 

exhaust hood. Check that vent is secured to exhaust hood 

with a 4" (102 mm) clamp.

Move dryer to final location, taking care not to crush or  

kink vent.

After dryer is in place, remove corner posts and cardboard 

from under dryer.

Check for leaks around “Y” connector, faucet, and hoses.