Maytag MEDC215EW-WW 手册

Dryer will not run

Door not closed completely.

Make sure the dryer door is closed completely.

PUSH to START knob not pressed 

firmly or held long enough.

Press and hold the PUSH to START knob until you hear the dryer 

drum moving.

Household fuse is blown or circuit 

breaker has tripped.

Electric dryers use 2 household fuses or circuit breakers. The drum 

may be turning, but you may not have heat. Replace both fuses or 

reset the circuit breaker. If the problem continues, call an electrician.

Incorrect power supply.

Electric dryers require 240-volt power supply. Check with a qualified 

electrician.

Wrong type of fuse.

Use a time-delay fuse.

Dryer will not heat

Household fuse is blown or circuit 

breaker has tripped.

The drum may be turning, but you may not have heat. Electric dryers 

use 2 household fuses or circuit breakers. Replace the fuses or 

reset the circuit breaker. If the problem continues, call an electrician.

Incorrect power supply.

Electric dryers require 240-volt power supply. Check with a qualified 

electrician.

Supply line valve not open.

For gas dryers, make sure that the valve on the gas supply line is 

open.

Thumping noise

Dryer hasn’t been used in a while.

This is normal. The thumping sound should diminish after a few minutes 

of use.

Rattling or vibrating noise

A small object caught between the 

edges of dryer drum.

Check the front and rear edges of the drum for small objects. Clean out 

pockets before laundering.

Dryer isn’t properly leveled.

The dryer may vibrate if not properly installed. See the Installation 

Instructions. All four dryer feet should be in firm contact with the 

floor.

Clothing is balled up in dryer.

When balled up, the load will bounce, causing the dryer to vibrate. 

Separate the load items and restart the dryer.

Clicking noise

Gas valve operating.

On gas dryers, you may hear the gas valve clicking as it opens  

and closes. This is normal.

Clothes are not drying 

satisfactorily or drying 

times are too long

Lint screen is clogged with lint.

Clean lint screen before each load.

The exhaust vent or outside exhaust 

hood is clogged with lint, restricting air 

movement.

Run the dryer for 5-10 minutes. Hold your hand under the outside 

exhaust hood to check air movement. If you do not  

feel air movement, clean exhaust system of lint or replace exhaust 

vent with heavy metal or flexible metal vent. See Installation 

Instructions.

The exhaust vent is not the correct 

length.

Check that the exhaust vent is not too long or has too many 

turns. Long venting will increase drying times. See “Installation 

Instructions”.

The dryer is not level.

Clothes not contacting the moisture sensors during Automatic 

cycles. See “Level the Dryer” in the Installation Instructions.

The exhaust vent diameter is not the 

correct size.

Use 4" (102 mm) diameter vent material.

The Air Fluff cycle has been selected.

Select the right cycle for the types of garments being dried.  

See Cycle Guide.

The load is too large and heavy to  

dry quickly.

Separate the load to tumble freely.

First try the solutions suggested here or visit our website at www.maytag.com/product_help - 

In Canada www.maytag.ca for assistance and to possibly avoid a service call.