GE AEM12AR 业主指南

4

  Delay  timer  Increase 

  Auto  Fan  on

Fan speed Increase

 Unit power on/off

NOTE: The display always 

shows the room temperature 

except when setting the Set 

temperature or the Delay timer.

Light indicates the 
delay timer is set.

Light indicates the unit 
is in the temperature or 
delay time Set mode.

Delay 1–24hr

Delay timer  
Decrease

  Mode  select

Fan speed  
Decrease

Temperature  
set Increase  
and Decrease

Features and appearance will vary. 
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.

 

Turns air conditioner on and off. When turned 

on, the display will show the room temperature.

 

Shows the room temperature or time remaining 

on the Delay timer. Shows the Set temperature 

while setting the temperature in Cool or Energy 

Saver modes. The Set light will turn on while 

setting.

Ÿ 

ź 

Use to set temperature when in Cool or Energy 

Saver mode. The Set light will turn on while 

setting.

Delay Timer IncreaseŸ (+) /Decrease ź(–) 

Each touch of the Increase Ÿ / Decrease ź 

pads on the unit or the Increase 

+ 

/ Decrease 

 pads on the remote control will set the delay 

time when using the Delay 1–24hr

 

timer. The 

Set light will turn on while setting.

 

Use to set the fan speed to Low, Med, High  

or Auto on the unit. NOTE: On the remote 

control, use the fan speed Increase 

 pads to set the fan speeds to Low, 

Med or High. Use the Auto pad to turn Auto  

fan on.

Use to set the air conditioner to Cool, Energy 

Saver or Fan Only mode.

'HOD\21³When the air conditioner is off, it can 

be set to automatically come on in 1 to 24 hours 

at its previous mode and fan settings. 
'HOD\2))³When the air conditioner is on,  

it can be set to automatically turn off in 1 to  

24 hours. 
How to set:
Press the Delay 1–24hr pad on the unit or the 

Delay pad on the remote control.  Each touch 

of the Increase Ÿ

 

/ Decreaseźpads on the 

unit or the Increase 

/ Decrease 

– 

pads on 

the remote control will set the timer in 1-hour 

intervals. The Set light will turn on while setting.
To review the remaining time on the Delay 

1–24hr timer, press the Delay 1–24hr pad on 

the unit or the Delay pad on the remote control. 

Use the Increase Ÿ / Decrease ź pads on the 

unit or the Increase 

+ 

/ Decrease 

– 

pads on the 

remote control to set a new time if desired.
To cancel the timer, press the Delay 1–24hr pad 

until the light on the Delay 1–24hr pad goes off.

Note: The default temperature reading on the display is degree Fahrenheit ( °F).  To change the display to 
degree Celcius (°C), press the Temp Increase Ÿ and Temp Decrease ź buttons together and hold for 3 

seconds.  Repeat the process to change back to degree Fahrenheit (°F)