Frigidaire FPID2497RF 用户手册
CAUTION
Property Damage Hazard
Before starting dishwasher be sure that the water
is connected and turned on. Failure to do so
may cause damage to the pump seal and result
in water leakage.
4
FEATURES AT A GLANCE
Features may vary according to model
Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms
against soiled surfaces. First, the dishwasher drains for a few seconds to remove soils dropped while
loading, then fi lls with water covering the fi lter area. Water is then pumped through the spray arms. Soil
particles go through and across the fi lter and down the drain as the water is pumped out. This series of
steps are repeated as needed. The number of water fi lls varies with the cycle being used.
Operating Instructions
Getting Started
1. Load Dishwasher (See Preparing and Loading
Dishes).
2. Add detergent (See Dishwasher Dispenser &
2. Add detergent (See Dishwasher Dispenser &
Detergents).
3. Add Rinse Aid, if needed (See Rinse Aid).
4. Select desired CYCLE (See Cycle Chart).
5. Select desired OPTION (See Options
3. Add Rinse Aid, if needed (See Rinse Aid).
4. Select desired CYCLE (See Cycle Chart).
5. Select desired OPTION (See Options
Selections).
6. Run hot water faucet nearest dishwasher until
6. Run hot water faucet nearest dishwasher until
water is hot. Turn water off.
7. To start, press START/CANCEL pad and close
7. To start, press START/CANCEL pad and close
door.
Recommended Cycle for typical
use:
The NORMAL WASH cyclen with its factory default
options of SPRAY and AIR DRY together provides
the best all around performance. This cycle
selection is recommended for everyday use and is
suitable for a large range of both dish load sizes
and food quantities remaining on those dishes.
Tub Gasket
Middle Spray
Arm
Lower Rack
Cup Shelves
Lower Spray
Arm
Detergent
Dispenser
Rinse Aid
Dispenser
Upper Spray Arm
Upper Rack
Silverware
Basket
Filter
Serial Label
(located on right
side of door)
Soft Grip Rack
Adjustable
Rack
Mechanism
Flex Wash