Maytag MEDB725BW 安装指导

Vent must fit over the exhaust hood. Secure vent to exhaust 

hood with 4" (102 mm) clamp. Run vent to dryer location using 

straightest path possible. Avoid 90° turns. Use clamps to seal 

all joints. Do not use duct tape, screws, or other fastening 

devices that extend into interior of vent to secure vent, 

because they can catch lint.

Turn cold water faucet off and remove washer inlet hose.

Check and see if rubber washer is in the “Y” connector.  

Remove old rubber washer from inlet hose and replace  

with new rubber washer provided. 

For non-steam models, skip to “Connect Vent.”

The dryer must be connected to the cold water faucet using  

the new inlet hoses. Do not use old hoses.

Using pliers, tighten the couplings with additional two-thirds  

turn.

NOTE: Do not overtighten. Damage to the coupling can result.

If space permits, attach the female end of the “Y” connector  

to the cold water faucet. See figure A.

If “Y” connector cannot be attached directly to the cold water 

faucet, the short hose must be used. See figure B. Attach short 

hose to cold water faucet. Screw on coupling by hand until  

it is seated on faucet. Then attach “Y” connector to male end  

of the short hose. Screw on coupling by hand until it is seated  

on connector.

Fig. A

Fig. B

Install exhaust hood and use caulking compound to seal 

exterior wall opening around exhaust hood.

NOTE: Bottom exhaust installations have a 90° turn inside the 

dryer. To determine maximum exhaust length, add one 90° turn 

to the charts.

100 ft. (30.5 m)

90 ft. (27.4 m)

80 ft. (24.4 m)

71 ft. (21.6 m)

63 ft. (19.2 m)

94 ft. (28.7 m)

84 ft. (25.6 m)

74 ft. (22.6 m)

65 ft. (19.8 m)

57 ft. (17.4 m)