Maytag MED4200BW 业主指南

OPTIONS

Use to select available options for your dryer. Not all cycles

and options are available on all models.

Drum Light (on some models)

Touch to turn the LED drum light on or off. The light

will also turn on when the door is open, and turn off

automatically after about 5 minutes.
Wrinkle Prevent

If you will be unable to remove a load immediately, touch

Wrinkle Prevent to add up to 140 minutes of periodic

tumbling to help reduce wrinkling.
Damp Dry Signal (on some models)

Touch to select the Damp Dry Signal. When selected, a

series of beeps will sound when the load is damp, but not

completely dry. This will allow you to take clothes out of

the load that do not need to dry completely. This option is

available on Heavy Duty, Normal, Bedding, and Delicates

cycles.
Cycle Signal (on some models)

Use this to turn the signal indicating the end of a drying

cycle on or off.
NOTE: You may also turn off the tones that sound when

a feature, setting, or option is touched. Touch and hold

Cycle Signal for about one second to turn sounds on

or off.
Control Lock

Use to lock the controls of the dryer and avoid

an accidental change in cycle options or preferences

during a drying cycle.
NOTE: The Control Lock function may be enabled when

recovering from a power failure. To unlock the control,

touch and hold CONTROL LOCK for at least 3 seconds.

CYCLE STATUS LIGHTS

The indicator bar on the right side of the control will let you

know what stage of the drying cycle is in process. For more

information on each stage, see “Cycle Status Indicators.”

POWER

Touch to turn the dryer on and off. Touch to stop/cancel

a cycle at any time.

CYCLE CONTROL KNOB

Use your dryer’s cycle control knob to select available cycles

on your dryer. Turn the knob to select a cycle for your laundry

load. See “Cycle Guide” for detailed descriptions of cycles.

START/PAUSE

Touch and hold until the LED comes on to start a cycle,

or touch once while a cycle is in process to pause it.

LED DISPLAY AND SETTINGS

When you select a cycle, its default settings will light up and

the Estimated Time Remaining (for Sensor Cycles) or actual

time remaining (for Timed Cycles) will be displayed. For times

longer than 99 minutes, hours will be displayed followed by

minutes.
Touch the words next to the display to adjust settings.

See “Cycle Guide” for available settings on each cycle.

Not all settings are available with all cycles.

Temperature

When using Timed Cycles or Refresh, you may select a

dry temperature based on the type of load you are drying.

Use the warmest setting safe for the garments in the load.

Follow garment label instructions.
NOTE: Sensor Cycles use a preset temperature that is

not adjustable.
Dryness Level

You may adjust the Dryness Level on Sensor Cycles

(except for the Sanitize cycle), if desired.
NOTE: Dryness Level is for use with Sensor Cycles only.

TIMED DRY ADJUST for TIMED CYCLES

Use with Timed Cycles to increase or decrease the length

of a Timed Dry or Rapid Dry cycle.