Whirlpool WDF775SAYB 业主指南

■

To add rinse aid, turn the dispenser 
cap to “Refill” and lift off. Pour rinse 
aid into the opening until the indicator 
level is at “Full.” Replace the 
dispenser cap and turn to “Lock.” 
Make sure cap is fully locked. 

NOTE: For most water conditions, the factory setting will give good 
results. 

■

Check water hardness level to ensure no rings or spots on your 
dishware before adding rinse aid or adjusting the factory 
setting.

■

If you have hard water or notice rings or spots, try a higher 
setting. 

Turn the arrow adjuster inside the 
dispenser by either using your fingers or 
inserting a flat-blade screwdriver into 
the center of the arrow and turning. 

See “Cycle and Option Descriptions” charts in the following 
section.

Heavier cycles and options affect cycle length.

See “Cycle and Option Descriptions” charts in the following 
section.

You can customize your cycles by pressing the options desired. 

■

Run hot water at the sink nearest your dishwasher until the 
water is hot. Turn off water. For best dishwashing results, water 
should be 120ºF (49ºC) as it enters the dishwasher.

■

For models with controls on top of the door, select 
wash cycle, option and press START/RESUME 
before closing the door. Push door firmly closed. 
The door latches automatically. Select the wash 
cycle, options and press STAR/RESUME or press 
START/RESUME to repeat the same cycle and 
options as in the previous wash cycle.

■

You can add an item anytime at the beginning of the cycle. 
Open the door slowly and add the item. Close the door firmly. 
Press START/RESUME.

Lock

Refill

6 5

4

3

2

max

fill

1

- -

-

-

- - -

-

-

-

-

¹⁄₄

Lock

Refill

6 5

4

3

2

max

fill

1

- -

-

-

- - -

-

-

-

-

max

fill

- -

-

-

- - - -

-

-

-

-