Amana ASD2575BRS 安装指南

NOTE: After dispensing, a few additional drops of water are normal.

■

Glass was not held under the dispenser long enough - Hold the glass under the dispenser for 
2 to 3 seconds after releasing the dispenser pad/lever.

■

New installation, or water filter was recently installed or replaced - Air in the water lines causes the 
water dispenser to drip. Flush the water system to remove the air in the water lines. See “Water and Ice 
Dispensers” in the User Instructions or User Guide.

■

Residual ice in the dispenser chute is melting - Make sure the ice chute is free of ice shavings or 
pieces.

■

Water line connections are not fully tightened - Make sure all connections are firmly tightened. See 
“Connect Water Supply.”

NOTE: Water from the dispenser is chilled to 50°F (10°C).

■

New installation - Allow 24 hours after installation for the water supply to cool completely.

■

Recently dispensed a large amount of water - Allow 24 hours for the new water supply to cool 
completely.

■

Water has not been recently dispensed - The first glass of water may not be cool. Discard the first 
glass of water dispensed.

■

Refrigerator is not connected to a cold water pipe - Make sure the refrigerator is connected to a cold 
water pipe. See “Water Supply Requirements.”