Whirlpool WED9371YL 手册

Use this button to turn the signal indicating the  

end of a drying cycle on or off. 

The Cycle Status indicators show the progress of a cycle. 

Sensing
  The Sensing indicator will light during Auto Cycles to  

indicate that the moisture sensor on the dryer is operating. 

This indicator will not light during Manual Cycles or options 

such as Wrinkle Shield

™

.

Wet
  The load is still wet and/or the cycle just started.  

In the Enhanced Touch Up or the Quick Refresh Steam 

Cycles (on some models), the Wet indicator comes on after 

the water has been sprayed into the drum, 4-5 minutes into 

the cycle. The Wet light illuminates until the dryer goes into 

Cool Down with 1 minute of time remaining. 

Damp
  This indicator is used with Auto cycles to show that the load 

is partially dried and items that you may wish to hang up or 

iron while still damp may removed. 

Cool Down
  The dryer has finished drying with heat, and is now tumbling 

the load without heat to cool it down and reduce wrinkling.   

Steam model shown

Done
  This will indicate that the selected cycle has ended and the 

load may be removed from the dryer. If the Wrinkle Shield

™

 

option has been selected, the dryer may continue to tumble 

the load, even if the Done indicator is lit.  

  This indicator will light if the Wrinkle Shield

™

 option has been 

selected and is running. The dryer will continue to tumble the 

load for up to 90 minutes after the cycle has ended.  

Steam (on some models)
  This indicator will light when the Steam function is active. 
 

NOTE: Steam is not available on all models or on all cycles. 

Control Lock
  This indicator will light when the controls are locked. Press 

and hold the Cycle Signal button for 3 seconds to unlock. 

Sensing

Wet

Damp

Cool

Down

Done

Wrinkle

Shield

Steam
Control Lock

If the dryer is running:  

Press and hold the Cycle Signal button for 3 

seconds to lock the controls of the dryer and 

avoid an accidental change in cycle options 

or settings during a drying cycle. Press and 

hold again for 3 seconds to unlock. 
To enable the Control Lock feature if the 

dryer is off, it is not necessary to press 

POWER before activating the Control Lock feature.