GE Monogram ZBD6900DII 规格指南

•  The dishwasher must be installed so that the drain hose 

is no more than 10 feet in length for proper drainage.

•  Water and power supply should enter in the  

shaded area.

•  Electrical and water connections are at the right front 

of the dishwasher. The hot water line should extend 
forward 30" to 40" from the rear wall. The electrical 
must extend forward at least 24" to reach the junction 
box.

•  To prevent siphoning, an air gap must be used when 

the waste tee or disposer connection is less than 18" 
above the floor.

Cabinets

Square

and

Plumb

Floor MUST

be Even with

Room Floor

This Wall Area 

must be Free of

Pipes or wires

34-1/2" Min.

Underside of

Countertop

to Floor

24" 

Min.

24" Min.

5"

5"

4"

4"

6"

24"

*24"

34"

Adjustable

to 35"

The dishwasher must be supplied with 120V, 60Hz, and 
connected to an individual properly grounded branch 
circuit protected by a 15- or 20-amp circuit breaker or 
time-delay fuse.

These dishwashers require a field installed 3/4” thick custom 

panel and custom handle. An installation template is 

packed with these models and may be obtained in advance. 

Order Pub. No. 31-30569-1. Complete panel installation 

instructions are included on the template.
CUSTOM PANEL SIZE REQUIREMENTS
HEIGHT
Panel height must 

•     If the panel height is 

more than 30-1/4” it 

will prevent the door 

from swinging open.

•   If the panel height is 

less than 30-1/16” it 

will not cover the  

dishwasher door 

frame.

•   The top of the custom panel must be flush with the top 

of the door. The 1/2” minimum gap between the top 

of the door and the bottom of the countertop must be 

maintained.

•     If the panel width is less than  

23-3/4” it will not cover the  

dishwasher frame.

ZPR0700S door panel provides a professional-style handle 

on a stainless steel door panel.

ZTB700 stainless steel tubular handle for installation onto a 

custom panel.
Before installing refer to installation instructions for 

Minimum 1/2" gap  

for Clearance

Countertop

 1/2" min.

23-3/4"

30-1/16" Min.

30-1/4" Max.

Minimum 1/2" gap  

for Clearance

Countertop

 1/2" min.

23-3/4"

30-1/16" Min.

30-1/4" Max.

For answers to your Monogram,

® 

GE Profile

™

 or  

GE

®

 appliance questions, visit our website at 

geappliances.com or call GE Answer Center

®

 

service, 800.626.2000.

As an EnErgy StAr

®

 

partner, gE has determined 

that this product meets the 

EnErgy StAr guidelines 

for energy efficiency.

Listed by 

Underwriters 

Laboratories

* Dishwasher models 

ZBD6900 and ZBD8900 
require a 3/4" thick 
custom panel and will be 
24-3/4" deep.

ZBD6920DSS/ZBD6900DII

GE Monogram

®

 Fully Integrated Built-In Dishwashers

150058