GE GTDX180EDWW 规格说明表单

下载
页码 3
For answers to your Monogram,
® 
GE Profile
 or  
GE
®
 appliance questions, visit our website at 
geappliances.com or call GE Answer Center
®
 
service, 800.626.2000.
Listed by 
Underwriters 
Laboratories
Specification Revised 3/14
370231
GTDX180ED/185ED 
GE
®
 6.0 cu. ft. capacity DuraDrum
 electric dryer
Electric Dryer Rating:
240V
5600W
24A
60Hz
208V
4400W
22A
60Hz
Exhaust Option: 4-way rear, right, left  
and bottom
Circuit Requirements:  An individual, 
properly-grounded branch circuit, protected 
by a 30-amp circuit breaker or a time-delay 
fuse, is required.
Note: Dryer wall outlet must be located within 
36" of service cord entry and acessible when 
dryer is mounted in position.
Installation Information: For complete 
information, see installation instructions 
packed with your dryer.
Dimensions and Installation Information (in inches)
Special Installation Requirements
Alcove or Closet Installation:
 
• If your dryer is approved for installation in an alcove or closet, it will be stated on a label  
  on the dryer back. 
• The dryer MUST be exhausted to the outside. 
•  Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 
0" either side; 3" front and rear
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”. 
•  Closet doors must be louvered or otherwise ventilated and must contain a minimum 
of 60 sq. in. of open area equally distributed. If this closet contains both a washer and 
a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.
• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.
Bathroom or Bedroom Installation:
• The dryer MUST be exhausted to the outdoors. 
•  The installation must conform with the local codes, or in the absence of local codes, 
with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.
Minimum Clearances other than Alcove or Closet Installation:
•  Minimum clearances to combustible surfaces are: 0" both sides; 3" rear
Dryer Exhausting Information : Use metal duct only, vertical and horizontal ducting.