GE GTD45EASJ-WS 规格说明表单

Listed by 

Underwriters 

Laboratories

GTD45EASJ 

Specification Created 7/15

5.7 cu. ft. Dryers

2

Back View

Power 

Cord Hole

30-1/2

5.8, 6.0 and 7.0 cu. ft. Dryers

5

Back View

Power 

Cord Hole

4-1/2

Power Cord LoCations

BaCk View

side View

rear View

eLeCtriC dryer rating:

5600W 24A

60Hz

4400W 22A

60Hz

exhaust oPtion: 4-way rear, right, left and bottom
CirCuit requirements:  An individual, properly-grounded 

branch circuit, protected by a 30-amp circuit breaker or a time-delay 

fuse, is required.
note: Dryer wall outlet must be located within 36" of service cord 

entry and acessible when dryer is mounted in position.
instaLLation information: For complete information, see 

installation instructions packed with your dryer.

dimensions and instaLLation information (in inChes)

sPeCiaL instaLLation requirements

aLCoVe or CLoset instaLLation: 

• If your dryer is approved for installation in an alcove or closet, it will be stated on a label  on the dryer back. 

• The dryer MUST be exhausted to the outside. 

•  Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 

0" either side; 3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52". 
•  Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of 

open area equally distributed. If this closet contains both a washer and a dryer, doors must contain a 
minimum of 120 sq. in. of open area equally distributed.

• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.
Bathroom or Bedroom instaLLation:
• The dryer MUST be exhausted to the outdoors. 

•  The installation must conform with the local codes, or in the absence of local codes, with the 

National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.

minimum CLearanCes other than aLCoVe or CLoset instaLLation:
•  Minimum clearances to combustible surfaces are: 0" both sides; 3" rear
dryer exhausting information : Use metal duct only, vertical and horizontal ducting.

22 1/2"

29 1/2"

27"

3 1/2"

1 3/4"

3 1/4"

8"

37 1/2"

44"

27"

5"

Power Cord 4 1/2"

11 3/4"

Side View

Rear View