Perlick 24" 45 Bottle Signature Series Wine Reserves - Solid Stainless Door - Left Hinge 操作指南

INSTALLATION

IMPORTANT NOTE: If installing on a concrete

floor, concrete fasteners are required and not

included with the anti-tip kit.

CAUTION

Any finished flooring should be protected with

appropriate material to avoid damage from mov-

ing the unit.

If unit has been laid on its back or sides, place unit

upright and allow minimum of 24 hours before con-

necting power.

Re-install the doors by removing the upper pivot pin

completely, sliding the door onto the lower pivot pin

and re-installing the upper pivot pin and fastening

tightly. Before moving the unit, make sure the door is

secured to the cabinet (tape may be required to hold

the doors closed).

Plug the unit into the 15 amp grounded out-

let located in the installation opening. With power

applied to the unit, check that the lighting and cool-

ing function operate properly, then turn off power to

the wall outlet at the circuit breaker.

WARNING

Shut off power to the wall outlet before installing

into the opening.

Check that the following are level and square:

•

Front face and interior opening

•

Installation opening and floor surface

•

Countertop bottom front edge

IMPORTANT NOTE: Leveling legs should not be

extend more than ¾” from bottom of the cabinet.

IMPORTANT NOTE: The floor under the unit must

be at the same level as the surrounding finished

floor.

If all surfaces are level:

Measure from the floor to the bottom of the

front edge of the countertop

Measure the rear of the unit cabinet from the

floor to top of cabinet, at back corners

Adjust rear legs so B measurement equals A

measurement. Using an adjustable wrench or pliers,

turn legs counterclockwise to raise the unit or clock-

wise to lower the unit

Slide the cabinet into position, making sure

the rear cabinet leveling legs slide under the anti-tip

devices. Push the cabinet into the opening until the

bottom front edge of the cabinet is flush with the

surrounding cabinetry or the leveling legs are tight

with the anti-tip devices.

IMPORTANT NOTE: The rear cabinet leveling legs

must be engaged under the anti-tip brackets.

Shim the front of the unit so the front face is

flush with surrounding cabinetry. Adjust the front

legs to support the countertop at the shimmed

height. Using an adjustable wrench or pliers, turn

legs counterclockwise to raise the unit or clockwise

to lower the unit. Countertop should be resting on

top of the unit.

IMPORTANT NOTE: If countertop is not resting en-

tirely on unit top, shim the countertop to prevent

damage to the countertop.

CAUTION

To prevent damage to the countertop and unit

underneath, do not place heavy objects on coun-

tertop directly above the unit.

Check interior door openings inside the cabi-

net to ensure the cabinet is level. Re-install all shelv-

ing and drawers. Take extreme care to insert sliding

shelving and sliding drawers squarely into slide

brackets and proper slide bracket grooves. When

sliding shelving and drawers are installed properly a

click should be heard from both slide bracket retain-

ing clips and should slide smoothly in the tracks.

When sliding shelving or drawers are pulled out to

full extension a stop is activated to prevent addition-

al pull-out.

CAUTION

Improper shelving or drawer installation may not

actuate slide stop mechanism.

Document No. Z2305