Marvel 15" Built-In Ice Maker - Black Cabinet and Black Door 用户手册

Observe and follow all local building codes when installing this 

appliance.

Attach the supplied water line adapter (Figure 6) to the water 

valve inlet on the back of the ice machine (See Figure 5). Be sure 

the rubber washer is in place in the inlet valve nut. Bend the 

1/4” copper tubing to suit your installation being sure not to kink 

the tubing. Use 1/4” copper tubing for your water supply which is 

available at any local hardware or plumbing supply store. A shut-

off valve is recommended. NOTE: DO NOT USE A SELF-PIERCING 

TYPE VALVE. Connect the copper tubing water supply to the cop-

per tubing from the adapter assembly with the provided brass 

union. Secure the water supply line to the back of the cabinet 

with the screw and clamp provided in the corner of the back 

panel. (See Figure 5).

Water pressure must be at a minimum of 20 psi for proper op-

eration and a maximum of 120 psi.

Make certain all water connections are watertight after instal-

lation. Form the tubing so that it will not vibrate against the 

cabinet body or kink when your ice machine is set in position.

•  Do not use any thread sealers on these water line fittings.

•  Do not use a “Reverse Osmosis” Filtering Device.

•  Softened water is not recommended. This will produce soft 

cloudy ice cubes that will stick together.

•  De-ionized water is not recommended. This water will not 

form solid ice cubes.

Water

Supply 

Line

Clamp and

Screw

Water supply

inlet

Figure 5

Back view of

ice machine

Rubber Washer

Adapter

Fitting Valve

Compression Fitting

Compression Nut

1/4” Copper Water

Supply Line (*)

From Water Supply to

Ice Maker

(*) Supplied by Customer

Figure 6

6