L'Equip XL Juicer 业主指南
Assembly
Always make sure the juicer is unplugged before
beginning assembly.
1. Place the juicebowl on
top of the motor base.
Guide ring located on the
underside of the juice bowl
should rest in
accompanying guide slot on
top of the motor base.
2. Set the blade/basket on
the hub in the center of the
juice bowl, and press down
until it feels snug.
3. Gently rotate the blade/
basket to ensure that it
turns freely. If initially it
failed to seat, this should
slip it into place. Double
check by pressing down
and spinning it again.
4. Place the clear cover
over the juice bowl with the
top of the motor base.
Guide ring located on the
underside of the juice bowl
should rest in
accompanying guide slot on
top of the motor base.
2. Set the blade/basket on
the hub in the center of the
juice bowl, and press down
until it feels snug.
3. Gently rotate the blade/
basket to ensure that it
turns freely. If initially it
failed to seat, this should
slip it into place. Double
check by pressing down
and spinning it again.
4. Place the clear cover
over the juice bowl with the
large pulp ejection opening toward the back of the juicer.
5. Place the tops of the clamps on the respective slots on
the cover, leaving the clamp hinges resting out. Press the
bottom of the clamps in, until they snap snugly into
place.
bottom of the clamps in, until they snap snugly into
place.
6. Place the pulp basket under the pulp spout behind the
juicer.