Electrolux E23CS78HPS 业主指南
23
More About Your Advanced Water Filter
The
PureAdvantage
TM
ice and water filter
systems is tested and certified by NSF
International to NSF/ANSI Standards 42 and
53
for the reduction of claims specified on the
performance data sheet.
This system should not be used on water that is
microbiologically unsafe or with water of unknown
quality unless the water has been adequately
disinfected before or after the filtration system.
Systems certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
NSF Test & Certification Results:
• Rated Capacity - 400 gallons
• Rated service flow - .5 gallons per minute
• Rated Pressure - Min: 30 psi, Max: 100 psi
• Operating Temp. - Min: 33° F, Max: 100° F
• Rated service flow - .5 gallons per minute
• Rated Pressure - Min: 30 psi, Max: 100 psi
• Operating Temp. - Min: 33° F, Max: 100° F
Changing The Filter
To replace your PureAdvantage
TM
water filter:
It is not necessary to turn the water supply off
to change the filter. Be ready to wipe up any
small amounts of water released during the filter
replacement. The bottom of the filter housing
includes two small water drainage holes, so be sure
to remove any stored food from the top shelf.
1 Turn Off the ice maker power switch.
2 Push the filter release button to the right of the
2 Push the filter release button to the right of the
cartridge to disconnect it.
If your refrigerator has not been used for a period of
time (during moving, for example), change the filter
before reinstalling the refrigerator.
3 Slide the old filter cartridge straight out of
the housing and discard it.
4 Unpackage the new filter cartridge and
slide it gently into the filter housing until it
stops against the snap-in connector at the
back of the housing.
5 Push firmly until the cartridge snaps into
place. When fully engaged, the front of the
filter cartridge should be flush with the filter
release button.
6 Turn On the ice maker power switch.
7 Press a drinking glass against the water
7 Press a drinking glass against the water
dispenser while checking for any leaks at
the filter housing.
8 To prime filter system and purge air from
water line, continue flushing. There will be
noticeable spurts and sputters as the system
pushes air out through the system and out
the dispenser nozzle. This is normal.
9 Press and hold the Filter Status button on the Ice
& Water Dispenser control panel for 3 seconds.
The light flashes red, amber, and green to
indicate the Filter Status has been reset.
NOTE
The o-rings on a new water filter are lubricated. To
ensure a good seal, please do not remove this lubricant.
NOTE
The
PureAdvantage
TM
ice and water system can
operate without filtration if you use a bypass in place of
the water filter cartridge. Please contact the Electrolux
Customer Care Center at 1-877-435-3287 or visit
our web site at www.electroluxicon.com to order the
bypass (Part No. 240396701).
NOTE
Ice jams in the ice maker and/or hollow ice cubes
(partially frozen cubed with water inside), may also
be a sign that your water filter needs changing.
Push in
and Click
to Install
Slide
Out to
Remove
Filter
Cartridge
Push
Button
to
Release