Electrolux E23CS78HPS 业主指南
8
Removing The Doors
Door
Screws
Hinge
Assembly
Pin
Closer
Hinge
To remove the freezer door:
1 Detach the multi-wire cable connector
located above the top hinge. Grasp both
sides of the connector firmly and pull apart.
sides of the connector firmly and pull apart.
Multi-Wire
Cable
Hinge
Screws
Top
Hinge
Closer
Pin
Hinge
Door
Water
Line
Tubing
Screws
Hinge
Assembly
2 Trace lightly around the hinge with a pencil.
This makes reinstallation easier.
3 Detach the water tube from the connector
located below the freezer door. The
connector releases when you press its outer
sleeve inward.
connector releases when you press its outer
sleeve inward.
4 Remove the screws from the top hinge and
pull the multi-wire cable through it. Lift the
door off of the bottom hinge.
door off of the bottom hinge.
5 Lay the door on its side to avoid damage to
the water tube extending from the bottom
hinge.
hinge.
6 Remove the plastic closer and pin from the
lower hinge assembly.
7 Remove the two bottom hinge screws and
hinge if necessary.
To reinstall the freezer door, reverse the above steps.
Once both doors are in place, ensure they are
aligned with each other and level (Please see To
level the doors using the lower hinge in Installation
section.), then replace the top hinge cover.
aligned with each other and level (Please see To
level the doors using the lower hinge in Installation
section.), then replace the top hinge cover.
4 Remove the plastic closer and pin from the
lower hinge assembly.
CAUTION
Be sure doors are set aside in a secure
position where they cannot fall and cause
personal injury.
position where they cannot fall and cause
personal injury.
To Disconnect
1. Press outer ring against face of fitting
2. Pull to
remove tube
To Connect
Insert tube and push until mark touches
face of fitting