Electrolux EI30DS55LB 业主指南

Before cleaning any part of the appliance, be sure all controls are turned OFF and 

the appliance is COOL. REMOVE SPILLOVERS AND HEAVy SOILING AS SOON 

AS POSSIBLE. REGULAR CLEANINGS WILL REDUCE THE NUMBER OF MAJOR 

CLEANINGS LATER

Glass, Painted and Plastic Body 

Parts and Decorative Trim

for general cleaning, use hot, soapy water and a cloth. For more difficult soils and 

built-up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30 to 

60 minutes. Rinse with a damp cloth and dry. 

DO NOT use abrasive cleaners on any 

of these materials; they can scratch.

before cleaning the control panel, turn all controls to OFF. Lightly spray the control 

panel with a liquid cleaner. Wipe with a soft cloth or paper towel. DO NOT use 

abrasive cleaners or scouring pads. These can permanently damage the control 

panel surface.

Broiler Pan and Grid, Griddle

Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 

1:1 solution of clear water and ammonia. if necessary, cover difficult spots with an 

ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a 

damp cloth, and then scrub with a soap-filled scouring pad. Rinse and wipe dry with 

a clean cloth. Remove all cleaners or the porcelain may become damaged during 

future heating.

Decorative Trim, Oven Racks, Oven 

Racks Support

Clean with hot, soapy water and a dishcloth. Rinse with clean water and a cloth. 

Cover stubborn spots with an ammonia-soaked paper towel for 30 to 40 minutes. 

Rinse. Cleaners made especially for stainless steel are recommended. Be sure 

to rinse the cleaners as bluish stains may occur during heating and cannot be 

removed.

Oven racks and oven rack supports must be removed from the oven during the self-

clean cycle for cleaning. If they are not removed, the self-clean cycle will not start. 

Clean them as described above.

To clean oven door, wash with hot, soapy water and a clean cloth. 

DO NOT immerse 

the door in water or clean the oven door gasket.

The oven gasket located on the inner frame of the door and visible when the door 

is opened is essential for a good seal. Care should be taken not to rub, damage or 

remove the gasket.

To remove burned-on fat on oven walls, moisten soiled parts with household 

ammonia, using a wet cloth. Complete cleaning with a damp cloth and use a fine 

steel wool scouring agent if necessary.