Electrolux EW30ES80RS 安装指导

5

Slide the unit into the cabinet. Make sure the center of the unit is 

aligned with the center of the cabinet cut-out.

 Remove the protective channels on each side of the cooktop (if 

provided).

The metal flange under each side of the cooktop

MUST be placed 

over the cabinet countertop for proper unit support. The cooktop 

should 

NOT rest directly on the countertop (see illustration 2) or else 

it could cause damage to the cooktop voiding the warranty. Level the 

unit if needed.

 After the 

installation, MAKE 

SURE that the unit 

is supported by 

the leveling legs 

and NOT by the 

cooktop.

The counter-top around the cut-out should be flat and leveled (see

hatched area on illustration 1)

H1

H2

H3

H4

Illustration 1

Shave Raised

Edge to

Clear Space 

for a 31½" 

(80 cm) Wide

 

Cooktop.

1 ½" Max.

(3,8 cm Max.)

Illustration 2

To successfully 

install the range, 

the initial level 

height from floor

to underside of 

cooktop frame 

should be at 

least 1/16" (0,16 

cm) taller than 

cabinet sides 

as measured in 

step 2.

Metal 

Flange

 Before installing the unit, 

measure the heights of 

the two (2) cabinet sides 

(H1-4), front and back 

(see illustration 1) from 

the floor to the top of the

counter.

 Level the range using the leveling legs and leveling 

device (if equipped) so that the height from the floor

to the underside of the cooktop glass frame is greater 

than the tallest cabinet measurement by at least 1/16" 

(0,16 cm) (see illustration 2).

 If the appliance is equipped with leveling device: Remove and discard the two rear 

leveling legs (in this case, they are only in place to stabilize the unit for the transport).