Philips BTM2460/96 快速安装指南
140 mm (5.51")
Wall mounting instructions
Drill holes on wall at hole
positions marked.*
EN
Note for mounting
To secure the mounting on wall, concrete wall is required.
Use screws to mount the device on the wall
To secure the mounting on wall, concrete wall is required.
Use screws to mount the device on the wall
1
Use this sheet as a template. Mark the position where you
want to hang the device on the wall (as shown above) and
then drill two 6mm diameter holes.
2
Secure the 2 dowels and 2 screws (both supplied) in the
holes respectively. Leave a gap of 5 mm between the head
of the screw and the wall.
3
Hang the device on the fastening screws.
ZH-TW
安裝注意事項
要確保穩固,請在水泥牆上安裝。
使用螺絲釘將裝置安裝在牆面上
1
將這張單子作為標示樣本。
在您想懸掛裝置的牆面標記位
置
(
如上所示
)
,然後鑽二個直徑
6
公釐的洞。
2
在鑽孔處安裝隨附的
2
根暗榫與
2
根螺絲釘。
螺絲釘頭
與牆面間保持
5
公釐的間隙。
3
將裝置掛在固定的螺絲上。
壁掛指示
在牆上標示處進行鑽孔。
*
BTM2460_96_Wall Mounting_v1.0