AMT Datasouth 4000 用户手册

1.  Ensure printer Power Switch is off "0".

2.  IMPORTANT: (FM4402 ONLY) Ensure the AC Voltage Select Switch is set to the

correct Voltage for this installation.

3.  Remove the yellow voltage setting label from the AC Inlet Receptacle .

4.  Connect the power cord to the AC Inlet Receptacle  located on the back of the printer.

5.  Connect AC power plug to a suitable AC source.

6.  Connect either Centronics Parallel cable or RS-232 Cable.

CAUTION (FM4402 ONLY):  Failure to properly set the AC
Voltage Select Switch will cause damage to the printer and will
Void the warranty.  Ensure this is set properly before connecting
the AC power cord.

 

 

AC Inlet Receptacle

Power Switch

AC Voltage Select Switch
(

FM4402 ONLY)