Xerox DocuPrint 96 参考指南
Output trays and bins
2-2
Guide to Performing Routine Maintenance
The purge tray holds up to 100 sheets of paper from 7 by 10
inches / 178 by 254 mm to 17 by 14 inches / 432 by 356 mm. No
message appears when the purge tray is full. Since a paper jam
can occur if the tray is overfilled, empty the purge tray at least
once a day.
inches / 178 by 254 mm to 17 by 14 inches / 432 by 356 mm. No
message appears when the purge tray is full. Since a paper jam
can occur if the tray is overfilled, empty the purge tray at least
once a day.
To empty the purge tray, simply remove the printed pages.
Checking and unloading high-capacity stacker (HCS) bins
The 4635 and 180 NPS/IPS printers can have up to four high-
capacity stacker (HCS) bins. The 96 NPS/IPS printer can have
up to two high-capacity stacker bins. Each high-capacity tray
holds 2500 sheets of 20lb (80 gsm) paper. (Refer to your Xerox
DocuPrint 96/4635/180 System Overview for additional
information on the high-capacity stacker bins.)
capacity stacker (HCS) bins. The 96 NPS/IPS printer can have
up to two high-capacity stacker bins. Each high-capacity tray
holds 2500 sheets of 20lb (80 gsm) paper. (Refer to your Xerox
DocuPrint 96/4635/180 System Overview for additional
information on the high-capacity stacker bins.)
NOTE: If you use large paper sizes such as A3 or 11 by 17
inches, the stacker may hold less than 2500 sheets. This is to
ensure that the stack is at a safe weight for lifting and unloading
by the operator.
inches, the stacker may hold less than 2500 sheets. This is to
ensure that the stack is at a safe weight for lifting and unloading
by the operator.
•
You can lower, pull out, and unload any bin not currently in
use, without interrupting printing, as long as another HCS is
ready to receive paper.
use, without interrupting printing, as long as another HCS is
ready to receive paper.
•
If you select a bin that is in use, the printer begins stacking in
the next defined high-capacity stacker bin if it is available. If
no stacker bin is available, printing stops.
the next defined high-capacity stacker bin if it is available. If
no stacker bin is available, printing stops.
•
Once a sheet is delivered to a stacker bin, each subsequent
sheet must be within 25 mm (approximately 1 inch) of the
length and width of the first sheet.
sheet must be within 25 mm (approximately 1 inch) of the
length and width of the first sheet.
Unloading a stacker bin
To unload a stacker bin:
1. Select a bin for unloading by pressing the Bin Unload button
on the bin control panel. (You can also select the bin for
unloading through the printer mimic of the printer control
console.)
unloading through the printer mimic of the printer control
console.)