Texas Instruments TMS320C6712D 用户手册
SPRS293A − OCTOBER 2005 − REVISED NOVEMBER 2005
21
POST OFFICE BOX 1443
•
HOUSTON, TEXAS 77251−1443
Table 14. Device Configurations Pins at Device Reset
(LENDIAN, EMIFBE, BOOTMODE[1:0], and CLKMODE0)
CONFIGURATION
PIN
GDP/ZDP
FUNCTIONAL DESCRIPTION
EMIFBE
C15
EMIF Big Endian mode correctness (EMIFBE)
When Big Endian mode is selected (LENDIAN = 0), for proper device operation the
EMIFBE pin must be externally pulled low.
EMIFBE pin must be externally pulled low.
This new functionality does not affect systems using the current default value of C15 pin=1. For
more detailed information on the Big Endian mode correctness, see the EMIF Big Endian Mode
Correctness portion of this data sheet.
more detailed information on the Big Endian mode correctness, see the EMIF Big Endian Mode
Correctness portion of this data sheet.
LENDIAN
B17
Device Endian mode (LEND)
0
–
System operates in Big Endian mode.
The EMIFBE pin must be pulled low.
The EMIFBE pin must be pulled low.
1
− System operates in Little Endian mode (default)
BOOTMODE[1:0]
C19, C20
Bootmode Configuration Pins (BOOTMODE)
00 –
Emulation boot
01 –
CE1 width 8-bit, Asynchronous external ROM boot with default
timings (default mode)
timings (default mode)
10 − CE1 width 16-bit, Asynchronous external ROM boot with default
timings
11 − Reserved, do not use
For more detailed information on these bootmode configurations, see the bootmode section of
this data sheet.
this data sheet.
CLKMODE0
C4
Clock generator input clock source select
0
–
Reserved. Do not use.
1
− CLKIN square wave [default]
For proper device operation, this pin must be either left unconnected or externally pulled up
with a 1-k
with a 1-k
Ω
resistor.