Roland RMP-12 用户手册

Getting Ready to Play

fig.triggerin.eps

Make sure that the cable that connects the

TRIGGER IN jack on the sound module’s side panel

to the TRIGGER OUT jack of the pad is connected

securely at both ends.

This cable is connected when the RMP-12 is shipped from

the factory.

Make sure that the plug is NOT in the position shown in

the photo below.

Loosen the two screws that fasten the cover of the

battery compartment, and remove the cover.

Install the supplied batteries into the battery

compartment, while carefully observing the

correct polarity (+/- orientation).

Insert the batteries from above the battery ties. Make sure

that the ends of the battery ties are not hidden below the

batteries.

As shown in the illustration, insert the batteries in order,

beginning at the top. You should insert the “+” end of each

battery first.

Firmly close the cover of the battery compartment,

and fasten it using the screws you removed in step 1.

Be careful not to pinch the battery ties when you close the

battery cover.

Check the Connections between the
Sound Module And the Pad

• Avoid outdoor use (practice) in rainy conditions. Such

use will cause malfunctions.

• Take care that dirt or other foreign matter does not

enter the inside of the unit from the underside of the

pad. Such foreign matter will cause faulty operation or

malfunctions.

• Do not insert your hand or fingers from the rear of the

pad. Doing so may cause injury to you, or may cause

the unit to malfunction.

TRIGGER OUT
jack

TRIGGER IN
jack

Install the Batteries

Battery ties

Battery cover

RMP-12_e.book 11 ページ２００８年７月１１日　金曜日　午前９時４５分