Husqvarna 556 用户手册

English

 –

 33

•

Loosen the screws that hold the starter against the 
crankcase and remove the starter.

•

Pull out the cord approx. 30 cm and hook it into the 
notch in the rim of the pulley. Release the recoil spring 
by letting the pulley rotate slowly backwards.

•

Undo the screw in the centre of the pulley and remove 
the pulley. Insert and fasten a new starter cord to the 
pulley. Wind approx. 3 turns of the starter cord onto 
the pulley. Connect the pulley to the recoil spring so 
that the end of the spring engages in the pulley. Fit the 
screw in the centre of the pulley. Insert the starter cord 
through the hole in the starter housing and the starter 

handle. Make a secure knot in the end of the starter 
cord.

•

Hook the starter cord in the notch in the pulley and 
turn the starter pulley about 2 turns clockwise.

Note! Check that the pulley can be turned at least a 
further 1/2 turn when the starter cord is pulled all the 
way out.

•

Lift up the starter pulley. See instructions under the 
heading Changing a broken or worn starter cord. 
Remember that the recoil spring is coiled under 
tension in the starter housing.

•

Remove the cassette with the recoil spring from the 
starter.