GE 5200 用户手册

The unit is unplugged

Make sure the Zoneline plug is

pushed completely into the outlet.

The fuse is blown/circuit

Check the house fuse/circuit breaker 

breaker is tripped

box and replace fuse or reset the breaker.

The unit is waiting for the

This is normal. The Zoneline will start 

compressor overload

again after it resets.

protector to reset

The unit is unplugged

Make sure the Zoneline plug is

pushed completely into the outlet.

The fuse is blown/circuit

Check the house fuse/circuit breaker 

breaker is tripped

box and replace fuse or reset the breaker.

The unit is waiting for the

This is normal. The Zoneline will start 

compressor overload

again after it resets.

protector to reset

Power failure

If power failure occurs, set the mode

control to 

. When power is restored

set the mode control to the desired setting.
There is a protective time delay (up to

3 minutes) to prevent tripping of the

compressor overload. For this reason, the

unit may not start normal heating or

cooling for 3 minutes after it is turned

back on.

Indoor airflow

Make sure there are no curtains, blinds

is restricted

or furniture blocking the front of the 

Zoneline.

Outdoor airflow

Make sure the rear grille is not restricted.

is restricted or

This can cause the unit to cycle off due to 

recirculated

the compressor overload.

The temp control may

Turn the control to a lower or higher

not be set high or low

setting. 

enough

The air filter is dirty

Clean the filter at least every 30 days.

The room may have been

When the Zoneline is first turned on

hot or cold

you need to allow time for the room to

cool down or warm up.

Outdoor air is

Set the vent control to the 

position.

entering the room