Husqvarna 87521HVE 用户手册

Read these instructions and this man 

u al in its entirety 

before you attempt to assemble or operate your new lawn 
mow er. 

IMPORTANT:  THIS LAWN MOWER IS SHIPPED WITH-
 OUT OIL OR GASOLINE IN THE ENGINE.

Your new lawn mower has been as sem bled at the factory 
with the ex cep tion of those parts left unassembled for ship-
ping purposes. All parts such as nuts, washers, bolts, etc., 
necessary to com plete the as sem bly have been placed in 
the parts bag. To ensure safe and proper operation of your 
lawn mow er, all parts and hard ware you assemble must 
be tightened se cure ly. Use the correct tools as nec es sary 
to ensure proper tightness.

1.    Remove loose parts included with mower.

2.    Cut down two end corners of  car ton and lay end panel 

down fl at.

3.      Remove all packing materials ex cept padding be tween 

upper and lower handle and padding holding operator 
presence control bar to up per handle.

4.    Roll lawn mower out of carton and check carton thor-

ougly for ad di tion al loose parts.

IMPORTANT:  UNFOLD HANDLE CAREFULLY SO AS 
NOT TO PINCH OR DAMAGE CON TROL CABLES. 

1.    Raise lower handle section to operating position and 

align hole in handle with one of the height positioning 
holes in the handle bracket.

2.   Insert handle bolt through handle and bracket and 

secure with knob.

3.    Repeat for opposite side of handle.

4.    Remove protective padding, raise upper handle sec-

tion into place on lower handle and tighten both handle 
knobs.

5.   Remove any packing material from around control 

bar.

Your handles may be adjusted for your mowing comfort. 
Refer to “ADJUST HANDLE” in the Service and Ad just ments 
sec tion of this man u al.