Transcend Information TS256 用户手册

 23

 
 

If an error occurs, first check the information listed below before taking your JetFlash for repair.    If 
you are unable to remedy a problem from the following hints, please consult your dealer, service 
center, or local Transcend branch office. 

Enter  Device Manager in Control Panel and enable the Auto-Insert function of the CD-ROM 
drive.    Alternatively, you can manually execute the JetFlash.EXE from the driver CD. 

Check followings: 

1. Is 

your 

JetFlash properly connected to the USB port?    If not, unplug it and plug it in again. 

2. Is your JetFlash connected to the Mac keyboard?  If yes, unplug it and plug it into an 

available USB port on your Mac Desktop instead. 

3.  Is the USB port enabled?    If not, refer to the user’s manual of your computer (or motherboard) 

to enable it. 

4.  Is the necessary driver installed?    If your computer is equipped with Windows 98SE, you must 

insert the Driver CD into the CD-ROM and refer to the “Driver Installation for Windows 
98SE” section to complete the driver installation before using your JetFlash.    A driver is not 
required for Win ME/2000/XP, Mac OS 9.0 or later, or Linux kernel 2.4 or later 

5.  Is the battery in the JetFlash? If yes, remove the battery and plug it in again. 

Check the following: 

1. Is 

the 

JetFlash connected to your computer?    If yes, unplug it. 

2. Is 

the 

HOLD switch set to “HOLD”?    If yes, set it to “OFF”. 

3.  Is the battery inserted in the right direction?    If not, reverse the battery. 

4.  Is the battery power used up?    If yes, replace it with a new one. 

As required, uninstall the driver and re-install it.  If it doesn’t work, see Recover JetFlash to 
format your JetFlash.