Renesas R5S72641 用户手册
Section 15 Serial Communication Interface with FIFO
R01UH0134EJ0400 Rev. 4.00
Page 723 of 2108
Sep 24, 2014
SH7262 Group, SH7264 Group
Bit Bit
Name
Initial
Value R/W
Value R/W
Description
2
0
R
Reserved
This bit is always read as 0. The write value should
always be 0.
always be 0.
1, 0
CKE[1:0]
00
R/W
Clock Enable
Select the clock source and enable or disable clock
output from the SCK pin. Depending on CKE[1:0], the
SCK pin can be used for serial clock output or serial
clock input. If serial clock output is set in clock
synchronous mode, set the C/
output from the SCK pin. Depending on CKE[1:0], the
SCK pin can be used for serial clock output or serial
clock input. If serial clock output is set in clock
synchronous mode, set the C/
A bit in SCSMR to 1, and
then set CKE[1:0]. Values other than B'00 cannot be
used for channels that do not have an SCK pin.
used for channels that do not have an SCK pin.
Asynchronous mode
00: Internal clock, SCK pin used for input pin (input
00: Internal clock, SCK pin used for input pin (input
signal is ignored)
01: Internal clock, SCK pin used for clock output
(The output clock frequency is either 16 or 8 times
the bit rate.)
the bit rate.)
10: External clock, SCK pin used for clock input
(The input clock frequency is either 16 or 8 times
the bit rate.)
the bit rate.)
11: Setting prohibited
Clock synchronous mode
00: Internal clock, SCK pin used for serial clock output
00: Internal clock, SCK pin used for serial clock output
01: Internal clock, SCK pin used for serial clock output
10: External clock, SCK pin used for serial clock input
11: Setting prohibited